ProForm PFBE1516.0 user manual Repeat this step with the other two Pad Tubes

Page 9

8.Orient the Seat (16) as shown. Attach the Seat to the Seat Frame (2) with two M6 x 23mm Screws (53), an M6 x 63mm Screw (54), and an M6 Washer (46).

9.Apply grease to the barrel of the M10 x 57mm Bolt Set (49) and to the face of each Bushing

(30).Attach the Leg Lever (10) to the Front Leg

(3)with the Bolt Set. Make sure the barrel of the

Bolt Set is inserted through both sides of the bracket on the Leg Lever.

10.Insert a Pad Tube (14) into the Leg Lever (10). Slide a Foam Pad (40) onto each end of the Pad Tube. Then, press a Pad Cap (24) into each Foam Pad.

Repeat this step with the other two Pad Tubes (14).

8
16
	2
	46	53
	54	53
	54
9
		Grease
			Bracket
Grease		49
Grease
10		30
10
		Grease	49
			3
10
24
40
	14		14
	14
		10
			14
		40
			24

9

Image 9

Contents QUESTIONS? Model No. PFBE1516.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Before YOU Begin Assembled DimensionsPart Identification Chart Make Assembly Easier AssemblyDo not tighten the Button Screws yet Button Screws yetTighten the Button Screws 47, 50, 59 used in and this step Locknuts yet Repeat this step with the other two Pad Tubes Repeat this step for the other side of the weight bench Adjusting the Backrest AdjustmentsUsing the Curl PAD Using the LEG LeverWeight Rests are at the same height Adjusting the Weight RestsStoring the Weight Bench Removing the Curl BARExercise Guidelines Muscle Chart Cooling DownStaying Motivated Date Exercise Weight Sets RepsAerobic Exercise Thursday Aerobic Exercise DateMonday Page Qty Description Part LIST-Model No. PFBE1516.0Exploded DRAWING-Model No. PFBE1516.0 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT