ProForm PFSY3415.0 user manual Repeat this step with the other Pull-up Handle

8.Slide the Top Frame (4) onto the Weight Guides (10). Attach the Top Frame to the Weight Guides with two M8 x 89mm Bolts (64), four M8 Washers (72), two 25mm Spacers (47), and two M8 Nylon Locknuts (74). Do not tighten the Locknuts.

Attach the Top Frame (4) to the Upright (3) with four M10 x 25mm Screws (58). Do not tighten the Screws.

Attach the Top Cover (15) to the Shroud (13) and Top Frame (4) with two M4 x 16mm Screws (70).

Tighten the two M8 Nylon Locknuts (74) and the four M10 x 25mm Screws (58).

9.Slide a Pull-up Cap (39) onto a Pull-up Handle (96). Insert the Handle into the Top Frame (4) and press the Cap onto the Top Frame.

Attach the Pull-up Handle (96) to the Top Frame

(4)with two M10 x 80mm Button Bolts (97), two M10 Washers (71), two M10 Split Washers (98), and two M10 Nylon Locknuts (73).

Repeat this step with the other Pull-up Handle (96).

10.Attach an Eyehook (66) to the Top Frame (4) with an M8 Washer (72) and an M8 Nylon Locknut

(74).Do not overtighten the Locknut; the Eyehook must rotate freely.

Repeat this step with the other Eyehook (66).

11.Attach the Press Arm (8) without the wire to the Upright (3) with four M10 x 25mm Screws (58).

Remove the M4 x 5mm Screw (69) and the Swivel Arm (16). Route the Press Arm Cable (30) through the Swivel Arm and the Press Arm (8) as shown.

Reattach the Swivel Arm (16) to the Press Arm

(8)with the M4 x 5mm Screw (69).

8	64	47
	72			72
		4		74
		58
		13
				10
	3			70
		58
				70
				15
9
		97		4
96	39
		71	98
		73		73
				96
10
	74
	72
	66	4
				66
11
		8	58	16
3				30
				69
				58

9