When your workout is complete, press (in Performance mode) or hold (in Multisport mode) to stop the chronograph.
View complete heart rate data in Review mode.
Care and Maintenance
Watch
INDIGLO® Night-light
Press the INDIGLO® button to activate the night light. This electroluminescent technology illuminates the watch display at night and in
Water Resistance
•The Global Trainer™ Bodylink® System Watch is Water Resistant to a depth of 50 meters and to a pressure of 86 p.s.i. This is equivalent to 164 feet below sea level.
•Water resistance is only maintained while the lens, pushbuttons, and case are intact.
•Rinse the Global Trainer™ Bodylink® System Watch with fresh water after any exposure to salt water.
CAUTION: TO MAINTAIN WATER RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.
Heart Rate Monitor
Heart Rate Monitor Strap Maintenance
After use, rinse the heart rate strap in fresh water to avoid buildup of materials that interfere with heart rate measurement.
Transmitter Battery Life
The battery on the Digital 2.4 Heart Rate Sensor should last more than two years if the sensor is used an average of one hour each day. More frequent or longer use will decrease the battery life. Replace the sensor transmitter battery if either of these conditions arise:
•When the sensor is properly placed on your chest, the Global Trainer™ Bodylink® System Watch cannot read heart rate data.
•Heart rate error messages (such as SEARCHING FOR HEART RATE . . . ) appear more frequently.
To Replace the Transmitter Battery
1.Use a coin to open the battery compartment cover on the back of the sensor.
2.Insert a new CR2032 battery (or equivalent) with the positive (+) facing you.
3.Use a toothpick or straightened paper clip to press the reset button next to the battery.
4.Reinstall the battery compartment cover.
To Test the Sensor After Battery Replacement
1.Move away from sources of radio or electromagnetic interference, such as other heart monitors or bike sen- sors.
2.Wet the heart rate sensor pads.
3.Fasten the sensor firmly to your chest, just below your sternum.
Turn on the Global Trainer™ Bodylink® System Watch.
Make sure the Global Trainer™ Bodylink® System Watch is set to scan for a heart rate sensor. See Sensors on page ?? for information about scanning for sensors.
If the heart rate sensor is functioning correctly, a solid heart icon appears in the status bar, and a flashing heart icon appears in the HR field on the performance view screen.
If these icons do not appear:
• Open the battery compartment cover, press the reset switch, and test again.
• Reinstall the battery, and test again.
•
34