2. Press to highlight POWER METER, then press .
3. Press or to highlight the setting to change, then press to open the setting change window.
4. Press or to highlight a selection in the setting change window, then press to confirm your selection.
Setting Group | Adjustment |
|
|
Threshold Power | Enter the threshold power in watts. The range is 0 to 600 |
|
|
View | Select watts or % of threshold |
|
|
Zones | Select CUSTOM to enter watt ranges for each zone manually, or select USE MAX |
| to automatically calculate values. |
|
|
Minimum / Maximum | Enter the minimum and maximum values for each zone. Press 8 to close the set- |
watts for zones 1 | ting change window. The minimum is 1. The maximum is 999. NOTE: You can only |
through 6 | change the zone values if Zones is set to CUSTOM. |
|
|
GPS
Configure options for the GPS, view device version information, and view satellites. You can also reset the watch and update the firmware from this menu.
To Configure GPS Settings
1.Press MODE until CONFIGURE displays.
2.Press to highlight GPS, then press .
3. Press or to highlight the setting to change, then press to open the.setting change window.
4. Press or to highlight a selection in the setting change window, then press to confirm your selection.
Setting Group | Adjustment |
|
|
GPS | Select OFF to turn the GPS system off. Select ON to turn the GPS system on. Set- |
| ting to off will increase battery life but workouts will not have positional or GPS |
| speed information. |
|
|
WAAS / EGNOS | Select OFF to use standard GPS positioning, which updates more quickly. Select |
| ON to enable WAAS/EGNOS, which is more accurate. |
|
|
Speed / Pace Smooth | Select OFF to update speed and pace data more quickly. Select ON to apply a |
| filter to get more stable speed and pace data. NOTE: Smoothing reduces large |
| variations in data due to GPS fluctuation. |
|
|
Altitude Smooth | Select OFF to update altitude data more quickly. Select ON to apply an averaging |
| filter to get more manageable altitude data |
|
|
Version
Press to highlight VERSION, then press to view the firmware version.
To upgrade the firmware:
1.While viewing the version screen, hold START/SPLIT for 2 seconds.
2.Press to highlight YES or NO, then press to confirm your selection. Select YES to upgrade the firmware, or select NO to return to the version screen without upgrading.
3.When prompted, insert the large
4.To back out of the firmware upgrade process, press ENTER and START/SPLIT at the same time. This will power off the device.
30