JVC RX-DP9VBK manual Adjusting the Surround Sounds Temporarily

Adjusting the Surround Sounds Temporarily

Activating the THX Surround and conventional Surround mode for a source automatically recalls the memorized settings and adjustments done on the Setup and Adjustment Menus.

However, if you want to modify the stored adjustments temporarily only for the current playback source, you can use the TEST button and the number buttons on the remote control.

IMPORTANT:

•When using the remote control:

Check the indication shown on the remote’s display when you press a button—this indicates the remote control operation mode for a while (10 or 5 seconds).

STANDBY ON

TV/CATV/DBS VCR 1

STANDBY/ON STANDBY/ON

1. Press SOUND. SOUND

The 10 keys are activated for sound adjustments.

2. Press TEST once to check the speaker

TEST

output balance.

The test tone comes out of all the activated speakers in the following sequence:

Left front speaker = Center speaker = Right front speaker

=Right surround speaker = Right surround back speaker

=Left surround back speaker = Left surround speaker

=Subwoofer = (Back to the beginning)

Notes:

•The LEVEL submenu (see page 37) appears on the TV screen.

•If “NO” or “NONE” is selected for a speaker on the SPEAKER SETTING submenu (page 29), test tone does not come out of that speaker, and adjustments in the following steps cannot be made.

Ex. When you press SOUND.

Before you start, remember...

•Adjustments using the number buttons are temporary and cannot be stored.

When you change the source or turn off the power, the adjustments are erased.

•Make sure that you have set the speaker information correctly (see page 29). You cannot select and adjust the output level of the speaker if the speaker is not activated (set to “NONE” or “NO”)

on the SPEAKER SETTING submenu.

CAUTION:

Test tone is automatically fixed to 0 dB, but this level will be louder than you would expect.

3. Select the speaker you want to adjust.

The selected speaker name appears on the			EFFECT
remote’s display for a while.	1	2	3
• To select the left front speaker, press			ROOM SIZE
	4	5	6
FRONT•L.
			LIVENESS
• To select the center speaker, press CENTER.	7/P	8	9
			WALL
• To select the right front speaker, press
	10	0	+10
FRONT•R.	RETURN	FM MODE	100+

•To select the right surround speaker, press SURR•R.

•To select the right surround back speaker, press SURR BK•R.

•To select the left surround back speaker, press SURR BK•L.

•To select the left surround speaker, press SURR•L.

•To select the subwoofer, press SUBWFR.

4. Press LEVEL +/– to adjust the speaker output levels.

The speaker name selected in the above step and its level appear on the unit’s display.

• You can adjust the levels as follows:

– Left and right front speakers	: –20 dB to +20 dB
– Other speakers	: –10 dB to +10 dB

5.Repeat steps 3 and 4 to adjust the other speaker output levels.

6.Press TEST again to stop the test tone.

42