JVC RX-DP9VBK manual Operating Other Manufacturers’ Equipment, Changing the Preset Signal Codes

TV

CATV/

DBS

Operating Other Manufacturers’ Equipment

This remote control supplied with the receiver can transmit control signals for other manufacturers’ VCRs, TVs, CATV converters, DBS tuners and DVD players. By changing the transmittable signals from preset ones to the other manufacturers’, you can operate the other manufacturer’s components using this remote control.

IMPORTANT:

When using the remote control:

– Set the TV operation mode selector to “TV” or “CATV/DBS” correctly.

To operate TV, set it to “TV.”

To operate the CATV converter or the DBS tuner, set it to “CATV/DBS.”

–Check the indication shown on the remote’s display when you press a button—this indicates the remote control operation mode for a while (10 or 5 seconds).

STANDBY ON

TV/CATV/DBS VCR 1

3. Press TV/DBS.

Remote’s display

4. Enter manufacturer’s code using buttons 1–9, and 0.

See page 61 to find the code.

TV/DBS

		EFFECT
1	2	3
		ROOM SIZE
4	5	6
		LIVENESS
7/P	8	9
		WALL
10	0	+10
RETURN	FM MODE	100+

STANDBY/ON STANDBY/ON

Ex. When you press VCR1.

CAUTION:

When replacing the batteries, finish it without delay; otherwise, manufactures’ codes are lost.

5. Release TV/CATV/DBS (STANDBY/ON).

After setting the TV operation mode selector to “TV,” you can perform the following operations on the TV:

TV/CATV/DBS	(STANDBY/ON) :
	Turns on or off the TV.
TV VOL +/–	: Adjusts the volume.
TV/VIDEO	: Sets the input mode (either TV
	or VIDEO).

After pressing TV/DBS (with the TV operation mode selector set to “TV”), you can perform the following operations on a TV:

Changing the Preset Signal Codes

By changing the transmittable signals from preset ones to the other manufacturers’, you can operate the other manufacturer’s components using this remote control.

•When operating the other manufacturers’ components, refer also to the manuals supplied with them.

CHANNEL +/– :Changes the channels.

1 – 10, 0, 100+ (+10): Selects the channels.

Number button 10 will function as the ENTER button if your TV requires pressing ENTER after selecting a channel number.

Notes:

•Refer to the manual supplied for your TV.

•All the functions listed above may not be assigned to the buttons for some TVs.

•If you cannot change the channels of some TVs by pressing number buttons, press CHANNEL +/– for changing the channels.

To change the transmittable signals for operating another manufacturer’s TV

6. Try to operate your TV by pressing

TV/CATV/DBS

1. Set the TV operation mode selector to

“TV.”TV

	CATV/
	DBS
2. Press and hold TV/CATV/DBS	TV/CATV/DBS
(STANDBY/ON).	STANDBY/ON

TV/CATV/DBS (STANDBY/ON). STANDBY/ON

When your TV turns on or off, you have entered the correct code.

If there are more than one code listed for your brand of TV,

try each one until the correct one is entered.

58