JVC RX-774PBK, LVT0014-001A, RM-SR774XU If necessary, adjust the speaker output level as follows

4.If necessary, adjust the speaker output level as follows:

•To adjust the center speaker output level, press CNTR +/–.

•To adjust the rear speaker output level, press REAR•(L) +/–.

Pressing – decreases the output level up to –10 dB. Pressing + increases the output level up to +10 dB.

CNTR MENU

2 3

ENTER REAR(L)

5 6

TEST

English

Notes:

range, which the human voice is mostly made up of. Each time you press the button, the display changes as follows:

SOFT2 SOFT1 FLAT SHARP1 SHARP2

Adjusted level are also shown on the equalizer display.

This CNTR means this adjustment can be applied to the center speaker only.

Note:

The center tone cannot be adjusted when “CENTER SPK” is set to “NONE” (see page 24).

100 1k 10k

To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much). To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much). When “FLAT” is selected, no adjustment is applied.

If you have selected Theater Surround, go to the following steps.

As the number increases, the surround effect becomes stronger.

Note:

When you have selected Dolby Pro Logic, you cannot select the effect level.

Note:

Once you have adjusted the Surround modes, the adjustment is memorized for each Surround mode.