Precor EFX LCD manual Cable

Page 18

Cardio Theater Integrated Bracket Assembly Instructions

16.Pull the cable and its two connectors out of the lower support and base tube.

Note: Remember to leave about 3 feet

(1 meter) of cable hanging out of the hole in the display console bracket.

17.Secure the upright support by replacing the four fasteners set aside in step 5.

CAUTION:The next step requires the use of a drill and the safety considerations that go along with operating power tools. Protect the work surfaces.Take the necessary steps to avoid injury to yourself or damage to the surrounding area and equipment.

18.Drill a hole in the end cap.

Use the ⁷⁄₈-inch drill bit to drill a hole through the center of the end cap.

19.Feed the cable and its two connectors through the hole in the end cap.

20.Replace the end cap in the base tube.

16

Lower support

Base tube

17

Rubber grommet

Read CAUTION above Step 18.

18

End cap

19

20

Coaxial/power

cable

Upright support

End cap

Preparing the EFX556i

page 18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents EFX Integrated LCD Screen Option Page Table of Contents Obtaining Service Unpacking the Equipment Before You BeginPreparations RequiredTools3Preparing the Unit Preparing the UnitPreparing the EFX546i Do not remove the handrail clamp screwsRubber grommet Upright support Handrail Upper support Upper Support Lower Back Front Preparing the EFX556i Preparing the EFX556iWhile you use a ¼-inch hex and ½-inch box Coaxial connector Replace two Screws at base Cable Rubber 4InstallAssemblythe Bracket Install the Bracket AssemblyBracket Assembly 5Attach the LCD Screen Attach the LCD ScreenDVD Reinstall the Bracket Cover 7Connect the Controller and the Cables Connect the Controller and the CablesPage
Top Page Image Contents