Precor EFX LCD manual Back

Page 12

Cardio Theater Integrated Bracket Assembly Instructions

19.Secure the upright support by replacing the four fasteners set aside in step 5.

20.Retighten the two handrail clamp screws.

Important: Look underneath the handrail clamp at the gap between the handrails.The area between the ends of the handrails should be no larger than a ¼-inch gap. If necessary, push the handrails toward each other before tightening the screws.

21.Replace the back cover and rubber grommet.

Replace the back cover onto the upright support. Fit the lip of the back cover into the tabs along the inside surface of the grommet. Apply pressure to the top of the back cover while you tighten the screws.

Rubber grommet

Upright support

19

Handrail clamp

Handrail

Display

console

20

Slide rubber grommet

21down so it fits snugly against the back cover.

Back

cover

Upright

support

Back

cover

Preparing the EFX546i

page 12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents EFX Integrated LCD Screen Option Page Table of Contents Obtaining Service Unpacking the Equipment Before You BeginPreparations RequiredTools3Preparing the Unit Preparing the UnitPreparing the EFX546i Do not remove the handrail clamp screwsRubber grommet Upright support Handrail Upper support Upper Support Lower Back Front Preparing the EFX556i Preparing the EFX556iWhile you use a ¼-inch hex and ½-inch box Coaxial connector Replace two Screws at base Cable Rubber 4InstallAssemblythe Bracket Install the Bracket AssemblyBracket Assembly 5Attach the LCD Screen Attach the LCD ScreenDVD Reinstall the Bracket Cover 7Connect the Controller and the Cables Connect the Controller and the CablesPage
Top Page Image Contents