Precor EFX LCD manual Rubber grommet Upright support

Page 8

Cardio Theater Integrated Bracket Assembly Instructions

5.Remove the four fasteners securing the upright support.

Use a ¼-inch hex and ½-inch box end wrench to remove the fasteners. Keep the fasteners together and within easy reach.

Important: Ask someone for help before completing the next step.

6.Separate the display console from its bracket.

Ask your assistant to hold the display console while you remove the four screws from the back of the display console bracket using a ⁵⁄₃₂-inch hex key. If the display console slides off the display console bracket, its weight can place excessive pressure on the data cable.

7.Remove the plastic plug.

Use your thumbs to pop the plastic plug from the display console bracket. Discard the plug.

Note: If no plug exists in the display console, you will need to drill a hole using a ⁷⁄₈-inch drill bit and electric drill.

5

Rubber grommet

Upright support

7

Plastic

plug

Assistant must hold onto

6 the display console to keep it from sliding.

Display

console

Display

console

bracket

Display console bracket

Preparing the EFX546i

page 8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents EFX Integrated LCD Screen Option Page Table of Contents Obtaining Service Unpacking the Equipment Before You BeginPreparations RequiredTools3Preparing the Unit Preparing the UnitPreparing the EFX546i Do not remove the handrail clamp screwsRubber grommet Upright support Handrail Upper support Upper Support Lower Back Front Preparing the EFX556i Preparing the EFX556iWhile you use a ¼-inch hex and ½-inch box Coaxial connector Replace two Screws at base Cable Rubber 4InstallAssemblythe Bracket Install the Bracket AssemblyBracket Assembly 5Attach the LCD Screen Attach the LCD ScreenDVD Reinstall the Bracket Cover 7Connect the Controller and the Cables Connect the Controller and the CablesPage
Top Page Image Contents