Precor EFX LCD manual Reinstall the Bracket Cover

Page 24

Cardio Theater Integrated Bracket Assembly Instructions

6 Reinstall the Bracket Cover

1.Prepare the fasteners for reinstalling the bracket cover.

Push the washers and bearings toward the bolt heads so there is room for the bracket cover to slide in flush against the pivot tube.

Important: Keep the bracket cover flanges flush with the pivot tube. The washers and bearings need to remain on the outside of the bracket flanges.

2.Hold the bracket cover above the pivot tube.

Apply pressure to the top of the bracket cover while you slide it into position.

3.Tighten the two top screws on the back of the LCD Screen.

Use a Phillips-head screwdriver to fully tighten the top two screws on the back of the LCD Screen. Access holes have been drilled through the bracket cover.

4.Secure the bracket cover.

Using a torque wrench and a ⁷⁄₃₂-inch hex key, retighten the two pivot tube fasteners to 120 in-lbs.

1

2

Top of bracket cover

Bracket

 

 

cover

 

 

Pivot tube

 

 

3

 

 

Bracket cover

4

 

 

 

Pivot tube

Reinstall the Bracket Cover

page 24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents EFX Integrated LCD Screen Option Page Table of Contents Obtaining Service Unpacking the Equipment Before You BeginPreparations RequiredTools3Preparing the Unit Preparing the UnitPreparing the EFX546i Do not remove the handrail clamp screwsRubber grommet Upright support Handrail Upper support Upper Support Lower Back Front Preparing the EFX556i Preparing the EFX556iWhile you use a ¼-inch hex and ½-inch box Coaxial connector Replace two Screws at base Cable Rubber 4InstallAssemblythe Bracket Install the Bracket AssemblyBracket Assembly 5Attach the LCD Screen Attach the LCD ScreenDVD Reinstall the Bracket Cover 7Connect the Controller and the Cables Connect the Controller and the CablesPage
Top Page Image Contents