Precor EFX LCD manual Preparing the EFX546i, Do not remove the handrail clamp screws

Page 7

Cardio Theater Integrated Bracket Assembly Instructions

Preparing the EFX546i

1.

Loosen the two screws on the handrail clamp

 

using a ⁵⁄₃₂-inch hex key.

 

Important: Leave the handrails in the clamp.

 

Do not remove the handrail clamp screws!

2.

Remove the front cover.

 

Loosen and remove the two screws securing

 

the front cover. Set the front cover and

 

fasteners aside.

1

Handrail clamp

Handrail

Display console

3

Rubber grommet

Front cover

3.

Move rubber grommet.

 

Slide the rubber grommet along the upright

 

support toward the display.

4.

Remove the back cover.

 

Loosen the two screws securing the back cover.

 

Slide the back cover away from its bracket and

 

set it aside.

 

Important: Do not remove the two screws

 

securing the back cover.

Loosen the two screws on the handrail clamp.

2

4

 

 

Front

 

cover

Back cover

Rubber grommet

Upright

support

Back

Upright

support

cover

 

Preparing the EFX546i

page 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents EFX Integrated LCD Screen Option Page Table of Contents Before You Begin Obtaining Service Unpacking the EquipmentRequiredTools PreparationsPreparing the Unit 3Preparing the UnitDo not remove the handrail clamp screws Preparing the EFX546iRubber grommet Upright support Handrail Upper support Upper Support Lower Back Front Preparing the EFX556i Preparing the EFX556iWhile you use a ¼-inch hex and ½-inch box Coaxial connector Replace two Screws at base Cable Rubber Install the Bracket Assembly 4InstallAssemblythe BracketBracket Assembly Attach the LCD Screen 5Attach the LCD ScreenDVD Reinstall the Bracket Cover Connect the Controller and the Cables 7Connect the Controller and the CablesPage
Top Page Image Contents