JVC RX-6000VBK manual Receiving Radio Broadcasts, Tuning in Stations Manually, Using Preset Tuning

English

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in Stations Manually

On the front panel ONLY:

1. Press FM/AM to select the band.

The MULTI CURSOR % / Þ / @/ # buttons can be now used for operating the tuner.

FM/AM

Using Preset Tuning

Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 30 FM and 15 AM stations.

To store the preset stations

Before you start, remember...

•Each time you press the button, the band alternates between FM and AM.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

		1. Tune in the station you want to preset (see
		“Tuning in Stations Manually”).
		If you want to store the FM reception mode for this station,
2. Press MULTI CURSOR %/ Þ	MULTI CURSOR	select the FM reception mode you want. See “Selecting the FM
		Reception Mode” on page 17.
repeatedly until “ – TUNING +”
appears on the display.

3. Press MULTI CURSOR @/ #	MULTI CURSOR
until you find the frequency you
want.

2. Press MEMORY.

MEMORY

• Pressing @decreases the frequency.

• Pressing #increases the frequency.

“CH-” appears and the channel number position starts flashing on the display for about 5 seconds.

Notes:

•When you hold MULTI CURSOR @ / # in step 3, the frequency keeps changing until a station is tuned in.

•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

When an FM stereo program is received, the STEREO indicator also lights up.

3. Press MULTI CURSOR @/ #to select a channel number while the channel number position is flashing.

Note:

MULTI CURSOR

You can use the 10 keys on the remote control to select the preset number. When using the 10 keys, be sure that they are activated for the tuner, not for the CD and others. (See page 29.)

4. Press MEMORY again while the	MEMORY
selected channel number is
flashing on the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

5. Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used number erases the previously stored one.

16