Huffy P/N 21463608 manual Dimple Hole

4.Bounce top and middle pole assembly (4 & 5) onto bottom pole section (6) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the pole identification mark on the bottom pole.

IMPORTANT!:

Align dimple of middle pole section (5) into trough of bottom pole section (6) as shown.

	TROUGH	1-1/2"
		Bottom pole
5"		ID
		STICKER

Bottom pole

DIMPLE

HOLE

5

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2"

MINIMUM OVERLAP, LEAVING 1- 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

4

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH

THE HARDWARE

6

WOOD SCRAP

(NOT SUPPLIED)

P/N 21463608 07/04 14