JVC RX-D206B, RX-D205S manual 0ch 2.1ch 3.0ch 3.1ch 0ch 4.1ch 5.0ch 5.1ch

Basic settings

To obtain the best possible sound effect from Surround/DSP modes (see pages 27 to 31), you need to set up the speaker and subwoofer information after all the connections are completed. From pages 15 to 20, how to set speakers and other basic items of the receiver are explained.

Setting the speaker information easily—Quick Speaker Setup

Quick Speaker Setup helps you to easily and quickly register the speaker size, speaker distance, and output level of each speaker according to your listening room to create the best possible surround effect.

•You can also register each speaker’s information manually. For details, see page 18.

1,7 2,4,6 1,3,5

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

1Press SETTING and turn MULTI JOG until

“QUICK SPK SET” appears on the display.

ANALOG

LR

S.WFR

2Press SET.

ANALOG

LR

S.WFR

3Turn MULTI JOG to select the appropriate number of connected speakers (speaker channel number).

As you turn the jog, the speaker channel number changes as follows.

•For the details of speaker channel number, see “Speakers (channels) number and the size” on page 16.

ANALOG

LR

S.WFR

2.0ch 2.1ch 3.0ch 3.1ch

4.0ch 4.1ch 5.0ch 5.1ch

6.0ch 6.1ch 7.0ch* 7.1ch

(Back to the beginning)

* “7.0ch” is the initial setting.

4Press SET.

ANALOG

LR

S.WFR

5Turn MULTI JOG to select the appropriate room size to match to your listening room.

As you turn the jog, the room size changes as follows.

•To select your appropriate room size, see “Room size and the speaker distance/output level” on page 16.

ANALOG

LR

S.WFR

S M L*(Back to the beginning)

* “L” is the initial setting.

6Press SET.

Quick Speaker Setup is now completed, then the display goes back to SETTING menu.

7Press SETTING.

NOTES

•This procedure will not be completed if you stop in the middle of the setting process.

•Once Quick Speaker Setup is performed, the speaker output levels are also set to appropriate values automatically (common to all sources). If you want to set the speaker output levels separately for each source, see “Adjusting the speaker output levels” on page 22.

CONTINUED ON THE NEXT PAGE

English

15