Dimension One Spas 2003 manual Temperature Unit, Heat Indicator Light

Aquatic Fitness System

2003 Owner’s Manual

Program the Number of Filter Cycles by pressing the PROGRAM

Number of Filter Cycles:button a 4th time. Whenever you are programming a filtration setting, the FILTER Icon will be displayed next to the word PROGRAM in the LED Digital Display Window.

To adjust the number of filter cycles to run during a 24-hour period, simply use the UP or DOWN Buttons to select the correct number. Your choices are 1, 2, 3, or 4 cycles per day. The factory default is 2 times per day.

Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot climates.

Temperature Unit:	Program the Temperature Unit by pressing the PROGRAM button
	a 5th time. The current Temperature Unit will be visible in the LED
	Digital Display Window.
	To adjust the Temperature Unit used to measure spa water
	temperature, simply use the UP or DOWN Buttons to select between
	Fahrenheit (ºF) and Celsius (ºC). The factory default setting is
	Fahrenheit.
	Exit the Programming Sequence by pressing the PROGRAM Button a 6th
	time. All changes will be saved.
	If you do not proceed with the programming within 60 seconds, the spa
	will automatically exit the programming sequence and revert to your
	previous settings. Any programming changes made up to that point
	would be saved.
Heat Indicator Light
	Heat Indicator Light:
	This Light is illuminated whenever the heater is on. Additionally, the
	HEAT Icon will also be displayed in the upper left corner of the LED
	Digital Display Window.

Dimension One Spas Icon (Logo) Button

Dimension One Spas ICON (Logo): The time of day can be viewed by pushing the Dimension One Spas ICON logo on the far right of the control. If no other button is pushed within 5 seconds, the display will revert to the spa water temperature reading.

The pre-set factory default is Fahrenheit. Using the PROGRAM

Button can change the clock.

22