Dimension One Spas 2003 manual Light

	Aquatic Fitness System
		2003 Owner’s Manual
Term (Cont.)		Definition
Heater		An 11kw 230v thermostatically controlled electric heater equipped
		with a high-limit temperature safety shut-off switch. If the high-limit
		safety switch trips, contact your authorized Aquatic Fitness
		System Dealer. See the Troubleshooting Guide for more
		information.
Jets		Return the water into the Aquatic Fitness System from the
		equipment. The HydroTherapy Jets produce a turbulent flow of
		water mixed with air to provide a concentrated body massage. The
		Swim Jets produce a high volume flow to provide a rapid current for
		swimming.
Light		Illuminates the Aquatic Fitness System vessel.
Load Sharing		When the circuit breaker size is smaller than the total power
		needed to operate both the heater and the jet pump at the same
		time, load sharing automatically turns off the heater when a jet
		pump is turned onto high speed.
Lock-Ring		Mechanism that affixes filter cover to filter housing. To remove
		cover, turn lock-ring counter-clockwise until it disengages with filter
		housing. When replacing the filter cover, turn lock-wring clockwise
		to firmly secure the cover.
Ozone Generator		A specialized ultraviolet light that changes oxygen into ozone for use
		in the water sanitation process.
Pressure Switch		Safety device(s) that sends a signal to the electronic control system
		that there is adequate water flow to turn the heater on.
Primary Pump		Produces water flow through the heater, filter, sanitation system
		and the main jets in the Aquatic Fitness System. The primary
		pump will operate automatically during filtration and heat cycles.
		This pump can also be operated manually by depressing the “jets”
		button on the Top Side Control which will allow you to choose
		between two speeds
		• Low speed for efficient water circulation during heating and
		filtration modes, and for gentle jet resistance or massage
		action.
		• High speed for maximum jet action.
Pump Union		A removable fitting that connects the pump to the Aquatic Fitness
		System’s plumbing.
Selector Valve		Located on the top edge of the Aquatic Fitness System or spa, it
		diverts jet power from one area of the Aquatic Fitness System
		or spa to another.
Serial Number		Please use the serial number in communication with your dealer.
Servicing Filter Element		To clean or replace the filter element, shut off power to the
		Aquatic Fitness System, loosen the lock-ring, remove the filter
		cover and pull the filter element from the filter housing. Depending
		upon use, you may simply rinse the filter element with a garden
		hose, or you may be required to soak the element in Filter Cleaner
		Solution. Replace any worn or damaged filter elements. It is always
		good practice to have a spare filter element, so that you can
		perform cleaning at your convenience.

33