9.Press a 2” Square Inner Cap (28) into the Press Seat Frame (7).
Slide the bracket on the Press Seat Frame (7) onto the indicated 5/16” x 2 1/2” Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16” Nylon Locknuts (64) onto the Bolts. Do not tighten the
Nylon Locknuts yet.
Attach the Press Seat Frame (7) to the Press Upright
(2) with two 5/16” x 2 3/4” Bolts (89), two 5/16” Washers (36), and two 5/16” Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet.
10.Lubricate the 3/8” x 3” Bolt (88). Attach the Leg Press Lever (83) to the Press Base (6) with the Bolt and a 3/8” Nylon Locknut (50). Do not overtighten the
Nylon Locknut; the Leg Press Lever must pivot easily.
11.Place two Weight Bumpers (51) over the indicated holes in the Weight Base (5). Slide a Weight Guide
(15)into each of the holes.
Attach the indicated Weight Guide (15) to the Weight Base (5) with a 3/8” x 2 3/4” Bolt (46), two 3/8” Flat Washers (48), and a 3/8” Nylon Locknut (50).
Slide six Weights (21) onto the Weight Guides (15).
Make sure the Weights are turned so the pin grooves point towards the floor.
Press a Weight Tube Bumper (18) into the lower end of the Short Weight Tube (17). Slide the Weight Tube into the center holes in the Weights (21).
Slide a Top Weight (16) onto the Weight Guides (15).
Note: Make sure the Top Weight is turned so the groove fits over the welded pin on the Weight Tube (17).
8
9 |
| 89 | 36 |
|
|
| |
| 7 |
| 64 |
|
|
| |
|
|
| 36 |
28 |
|
|
|
|
| 89 |
|
64 | 64 |
| 2 |
|
| ||
|
|
| |
|
|
| 6 |
| 92 |
|
|
10 |
|
|
|
| 83 |
|
|
|
|
| 6 |
| 50 |
| Lubricate |
|
|
| 88 |
11 | 15 |
|
|
|
|
| |
| 16 |
|
|
| Groove |
|
|
| Pin |
|
|
| 17 |
|
|
|
| 18 |
|
| 21 |
|
|
Pin |
|
|
|
Grooves |
|
| |
|
| 51 |
|
|
| 48 |
|
|
|
| 50 |
| 5 |
|
|
| 48 |
|
|
| 46 |
|
|