Weider 9940 specification

39.Important: Although the following steps are not difficult to perform, the correct routing of the cable is critical to the functioning of the home gym. Please make sure that you wrap the cable around the pulleys exactly as shown in each step.

Route the Press Cable (72) through the opening in the Press Frame (8), and wrap the Cable around a

3 1/2” Pulley (24) in the direction shown. Route the end of the Cable back through the opening in the Press Frame.

Attach the Pulley (24) to the indicated hole in the Press Frame (8) with a 3/8” x 3 1/4” Bolt (62), a 3/8” Flat Washer (48) and a 3/8” Nylon Locknut (50).

Make sure the Pulley is mounted on the inside of the Press Frame. Make sure the Cable Trap is ori- ented as shown.

40.Wrap the Press Cable (72) around a “V”-Pulley (27) in the direction shown. Attach the “V”-Pulley and a Large Cable Trap (32) to the small tube on the Press Upright (2) with a 3/8” x 3 1/4” Bolt (62), a 3/8” Flat Washer (48) and a 3/8” Nylon Locknut (50). Note:

The small tube has four adjustment holes. Mount the “V”-Pulley in the hole farthest from the Upright. Make sure the Cable Trap is oriented as shown.

41.Route the Press Cable (72) back through the opening in the Press Frame (8) and wrap the Press Cable around a 3 1/2” Pulley (24) in the direction shown. Then, route the Press Cable back through the open- ing in the Press Frame (8).

Attach the Pulley (24) to the indicated hole in the Press Frame (8) with a 3/8” x 3 1/4” Bolt (62), a 3/8” Flat Washer (48), and a 3/8” Nylon Locknut (50).

Make sure the Pulley is mounted on the inside of the Press Frame. Make sure the Cable Trap is ori- ented as shown.

42.Wrap the Press Cable (72) around a 3 1/2” Pulley

(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to the indicated hole on the far side of the Press Upright (2) with a 3/8” x 4 3/4” Bolt (60) and a 3/8” Nylon Jamnut (63). Note: Thread the

Jamnut only two turns onto the Bolt; you will later attach another Pulley to the Bolt. Make sure the Cable Trap is oriented as shown.

Route the Press Cable (72) back through the opening in the Press Frame (8), so the end is in front of the Press Frame.

39
	50
		72
	24	48
	24	62
		62
		8
		25
40		50
	2	48
	2
		Small tube,
		last hole
		32
		27
		72
		62
41	62
	62
	48
		72
25		8
	24	50
42
	60	24
	60
		2
	72	25
	72	63
		63