Weider 9940 user manual Make sure the Cable Trap is oriented as shown

43.Wrap the Press Cable (72) around a 3 1/2” Pulley

(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to the indicated hole on the far side of the Leg Press Lever (83) with a 3/8” x 4 3/4” Bolt

(60)and a 3/8” Nylon Jamnut (63). Note: Thread the

Jamnut only two turns onto the Bolt; you will later attach another Pulley to the Bolt. Make sure the Cable Trap is oriented as shown.

44.Wrap the Press Cable (72) around a “V”-Pulley (27) in the direction shown. Attach the “V”-Pulley and a Large Cable Trap (32) underneath the Press Seat Frame (7) with a 3/8” x 4 1/4” Bolt (85), a 3/8” Flat Washer (48), and a 3/8” Nylon Locknut (50). Note: the Press Seat Frame has five adjustment holes. Mount the “V”-Pulley in the hole closest to the Leg Press Lever. Make sure the Cable Trap is ori- ented as shown.

45.Wrap the Press Cable (72) around a 3 1/2” Pulley

(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to the near side of the Leg Press Lever (83). Use the 3/8” x 4 3/4” Bolt (60) that was inserted in step 43 and secure the Pulley with the 3/8” Nylon Jamnut (63). Make sure the Cable Trap is oriented as shown.

46.Wrap the Press Cable (72) around a 3 1/2” Pulley

(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to near side of the Press Upright (2). Use the 3/8” x 4 3/4” Bolt (60) that was inserted in step 42 and secure the Pulley with the 3/8” Nylon Jamnut (63). Make sure the Cable Trap is oriented as shown.

Wrap the Press Cable (72) around a 3 1/2” Pulley

(24)in the direction shown. Attach the Pulley and a Cable Trap (25) to the 3/8” x 4” Carriage Bolt (102) that was inserted into the Press Base (6) earlier.

Secure the Pulley with the 3/8” Nylon Locknut (50).

Make sure the Cable Trap is oriented as shown.

18

43
	72
60
24
	25
83			63
44
48	85	7
27		32
72
	50
45
83
	24
60
25			8
	72
	63
46			50
			24
2			25
			102
			25
			72
	60	24	63