Weider 8530 manual 3/8Ó Nylon Locknut Locate the Short Cable 23. Route

CABLE ASSEMBLY

17. Route the Medium Cable (58) around the	17
3 1/2Ó Pulley (15) attached to the bracket on
	55	15	12
the Top Frame (55). Tighten the 3/8Ó x 2Ó Bolt
(12) and the 3/8Ó Nylon Locknut (21). (Note:	Bracket
This Pulley is pre-assembled. It has been			58
shown disassembled for easy part identifica-
tion.) Be sure that the Cable is in the
groove of the Pulley and that the Cable
and Pulley move smoothly.
18. Remove the 3 1/2Ó Low Pulley (95) from the	21
Press Frame (17). Reattach the Pulley with
the 5/8Ó x 9/16Ó Spacer (7) between the
Pulley and the Press Frame. Hand-tighten
the 3/8Ó Nylon Locknut (21).	18
Locate the Short Cable (23). Route the
Short Cable under the 3 1/2Ó Low Pulley (95).	15	23	9
Be sure that the end of the Cable with the
ball is on the indicated side of the Press	21		88
Frame (17) and that the Cable is between
			Ball
the Pulley and the crossbar on the Press
Frame. Tighten the 3/8Ó Nylon Locknut (21)			7
and 3/8Ó x 3 3/4Ó Bolt (88).
	42		95
		Crossbar 21
Route the Short Cable (23) around the 3 1/2Ó
	17
Pulley (15) attached to the lower hole in the
Front Upright (42). Be sure that the Cable
Trap (not shown) is turned to hold the
Cable in place and that the Cable is routed	19
around the Pulley as shown. Tighten the
	15
3/8Ó Nylon Locknut (21) and 3/8Ó x 3 3/4Ó Bolt
	23	15
(not shown).
		21
19. Route the Short Cable (23) around the 3 1/2Ó	21	66
Pulley (15) attached to the upper hole in the		12
Press Frame (17). Be sure that the Cable		9	3
Trap (66) is in the Ò3 oÕclockÓ position and
	42	6
that the Cable is routed around the Pulley
as shown. Tighten the 3/8Ó Nylon Locknut
(21) and 3/8Ó x 3 1/2Ó Bolt (not shown).	17
Route the Short Cable (23) around the 3 1/2Ó
Pulley (15) attached to the upper hole in the
Front Upright (42). Be sure that the Cable	20
Trap (not shown) is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown. Tighten the
3/8Ó Nylon Locknut (21) and 3/8Ó x 3 3/4Ó Bolt
(not shown).
20. Attach the end of the Short Cable (23) to the	2	57
Long ÒUÓ-Bracket (57) with a 1/4Ó Nylon
Locknut (2) and a 1/4Ó Flat Washer (10). Do	10
not tighten the 1/4Ó Nylon Locknut. It		23
should be threaded onto the Cable only a
couple of turns.

10