Weider 8530 manual Tube are sitting in the pin grooves in the top Weight

Page 6

FRAME ASSEMBLY

5.Press a Weight Tube Bumper (64) into the end of a Weight Tube (63). Insert the Weight Tube into the front stack of Weights (25). Be sure that the pins on the Weight Tube are sitting in the pin grooves in the top Weight.

Lubricate the inside of the holes in a Top Weight (65). Set the Top Weight onto the front stack of Weights (25). Insert both Long Weight Guides (62) into the stack of Weights.

Be sure that the holes in the Weight Guides are at the top, as shown.

6.Press a Weight Tube Bumper (64) into the end of the other Weight Tube (63). Insert the Weight Tube into the rear stack of Weights (25). Be sure that the pins on the Weight

Tube are sitting in the pin grooves in the top Weight.

Lubricate the inside of the holes in the other Top Weight (65). Set the Top Weight onto the rear stack of Weights (25). Insert both Short Weight Guides (73) into the stack of Weights.

Be sure that the holes in the Weight Guides are at the top, as shown.

6

5
Holes	62
	62
Lubricate	65
Lubricate
	Pin
63	64
	64
	25
6
	Holes
	73
Lubricate
65	Pin
	Pin
63
64
25

Image 6

Contents Customer HOT Line QUESTIONS?Model No. WESY85301 Serial No Mon.ÐFri., 6 a.m.Ð6 p.m. MSTTable of Contents Important PrecautionsDimensions Before YOU BeginChart located in the center of this manual AssemblyFrame Assembly Following Tools not Included are Required for AssemblyNylon Locknuts yet Tighten all of the Nylon Locknuts used in steps 1Ð3Tube are sitting in the pin grooves in the top Weight Frame Assembly ARM Assembly On each Arm. Arm identification is very Important for stepRight Arm is behind the indicated bracket On the Top FrameCable Assembly Be sure that the ball is on the indicated3/8Ó Nylon Locknut Locate the Short Cable 23. Route Be sure that the end of the Cable withPulley and the crossbar on the Press Cable Assembly Cable Trap is turned to hold the Cable in place Cable Assembly Seat Assembly Insets show viewFrom other side Seat Assembly VKR Assembly VKR Assembly Decals HOW to USE the Home GYM System Changing the Weight SettingWeight Resistance Chart Attaching and Removing the SeatAttaching the LEG Lever to the LOW Pulley Station Tightening the Medium and Short Cables TROUBLE-SHOOTING and MaintenanceTightening the Cables Tightening the Long CableCable Diagram TOP ViewPart LISTÑModel No. WESY85301 Qty DescriptionExploded Page 2 Inner Cap 32Ð4 Inner Cap 27Ð5 Outer Cap 51Ð2 Page Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT