Weider 8530 manual Frame Assembly ARM Assembly

FRAME ASSEMBLY

ARM ASSEMBLY

7.	Attach the upper ends of the Long Weight	7
	Guides (62) to the Top Frame (55) with a
	5/16Ó x 6Ó Bolt (60), two 1/2Ó x 3/4Ó Spacers		61	3	61
	(61), and a 5/16Ó Nylon Locknut (3).					3
	Be sure that the Pulley Bracket (20) is in					55
		60
	front of the right Long Weight Guide (62)
	as shown.
	Attach the upper ends of the Short Weight			60
	Guides (73) to the Top Frame (55) with a
	5/16Ó x 6Ó Bolt (60), two 1/2Ó x 3/4Ó Spacers		73	20
	(61), and a 5/16Ó Nylon Locknut (3).					62
8.	Press a 1Ó x 7/8Ó Plastic Bushing (90) onto	8
	each welded spacer on the Press Frame (17).
	Slide the Press Frame into place onto the
	Base (4). Note: This will be a tight fit. The
	Plastic Bushings should fit on each end of					59
	the indicated tube in the Base. Make sure
						17
	that the pulleys are on the side shown.
	Lubricate the 3/8Ó x 8Ó Bolt (59). Attach the					Lubricate
	Press Frame (17) to the Base (4) with the
	3/8Ó x 8Ó Bolt and a 3/8Ó Nylon Locknut (21).	4ÑTube				Welded
						Spacers
					21	90
9.	Wet the handle of one Press Arm (46) with	9				44
	soapy water. Slide a 5Ó Plastic Grip (83) onto
						49
	the handle. Press a 1Ó Round Inner Cap (49)
					83
	into the other end of the handle. Press a
						Handle
	1 3/4Ó Inner Cap (44) into the Press Arm.
	Attach the Press Arm (46) to one side of the					46
	Press Frame (17) with two 5/16Ó x 2 1/2Ó
					22
	Bolts (22) and two 5/16Ó Nylon Locknuts (3).
	Assemble the other Press Arm (46) in the
	same manner.		46			3
						17
10.	Identify the Right Arm (48) and the Left Arm	10	86			31
	(47). Note the position of the welded bracket
						50
	on each Arm. Arm identification is very		31
	important for step 11.
	Attach a ÒVÓ-Pulley (50) and a Long Cable		50			47
			Welded
	Trap (31) to the Right Arm (48) with a 3/8Ó x		Bracket
	2 1/2Ó Bolt (86) and a 3/8Ó Nylon Locknut				21
	(21).
	Attach a ÒVÓ-Pulley (50) and a Long Cable
	Trap (31) to the Left Arm (47) in the same		48
	manner.

7