Weider WESY29521 user manual

25.Route the Leg Press Cable (95) through the Left Leg (36) and the Left Upright (7) as shown. Wrap the Cable around a 90mm Pulley (38). Attach the Pulley inside the Upright with an M10 x 70mm Bolt (81), two M10 Washers (75), two 13mm Spacers (34), and an M10 Nylon Locknut (70).

26.Wrap the Leg Press Cable (95) around a 90mm Pulley (38). Attach the Pulley inside the bracket on the Left Top Frame (3) with an M10 x 45mm Bolt (66) and an M10 Nylon Locknut (70).

27.Attach the end of the Leg Press Cable (95) to the “U”-Bracket (85) with an M8 Washer (26) and an M8 Nylon Locknut (71). Note: Do not complete- ly tighten the Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing.

28.Locate the Butterfly Cable (46). Attach the Cable to the Pivot Bracket (48) on the Left Butterfly Arm (10) with an M8 x 16mm Shoulder Bolt (78) and an M8 Nylon Locknut (71).

25
38		70
34
	75
75
34
7
95
81	36
26
3
		70
66
38
95
27
95
26
	95
71
85		71
28
	71
		46
10	48	78
13