Weider WESY29521 user manual

37.Attach the end of the Leg Lever Cable (96) to the other “U”-Bracket (85) with an M8 Washer (26) and an M8 Nylon Locknut (71). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset draw- ing.

38.Locate the Low Cable (47). Route the small ball on the Cable through the cage on the Leg Press Frame (30).

Attach a 90mm Pulley (38) inside the Leg Press Frame (30) with an M10 x 70mm Bolt (81), two M10 Washers (75), two 13mm Spacers (34), and an M10 Nylon Locknut (70).

39.Route the Low Cable (47) through the Left Leg

(36)and the Left Upright (7). Attach a 90mm Pulley (38) inside the Upright with an M10 x 70mm Bolt (81), two M10 Washers (75), two 13mm Spacers (34), and an M10 Nylon Locknut

40.Wrap the Low Cable (47) around a 90mm Pulley

(38).Attach the Pulley and a Cable Trap (91) to the lower set of holes in the indicated “U”-Bracket

(85)with an M10 x 50mm Bolt (62) and an M10 Nylon Locknut (70). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.

37
			96	96
			26
			71	71
		85
38
			30
		38	34	70
				75
		34		Cage
	81		75	47
39
			34
		38	75
			70
			47
			36
	75	34
81		7
40
		85
		62	70
			91
		38
			47

16