Weider WESY19511 user manual Cable Diagram, Long Cable 23 TOP View, Short Cable

Page 20

CABLE DIAGRAM

The cable diagram below shows the proper routing of the Short Cable (58) and the Long Cable (23). Use the diagram to be sure that the two cables and the cable traps have been assembled correctly. If the cables have not been correctly routed, the weight system will not function properly and damage may occur. The numbers show the correct route for each cable. The starting and ending points of each cable are labeled. Be sure that the cable traps do not touch or bind the cables.

2

7

5

6

Weight Stack—8

1—High Pulley

3

4

Long Cable (23) TOP VIEW

5—Long “U”-Bracket

Short Cable (58)

4

3

1—Low Pulley

2

20

Image 20

Contents QUESTIONS? Model No. WESY19511 Serial NoTable of Contents Important Precautions DecalUsing the Weider 8525 weight system. If you have Before YOU BeginFor your benefit, read this manual carefully before Right SideMake Things Easier for Yourself AssemblyFrame Assembly Tighten the Nylon Locknuts used in steps WeightsDo not tighten the Nylon Locknuts yet Arm Assembly Weight Guides are at the top, as shownArm 47 refer to to identify the Right Arm. Arm identification is very important for StepFul not to confuse the Right Arm with the Left Cable Assembly Cable Trap is positioned to hold the Cable in placeThat the Cable Trap is inside the U-Bracket From other side Locate the Short Cable 58. Lay the ShortInset shows view Inset shows view Seat Assembly Page Page Adjustments Changing the Weight SettingAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart Troubleshooting and Maintenance Tightening the CablesShort Cable Cable DiagramLong Cable 23 TOP View Page Part LIST-Model No. WESY19511 Key No. Qty DescriptionExploded DRAWING-Model No. WESY19511 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty Remove this Part Identification Chart from the Manual Part Identification CHART-Model No. WESY19511 R0802B Page 50mm Square Outer Cap