Weider WESY19511 user manual Inset shows view

Page 12

22.Route the Short Cable (58) around the 90mm Pulley (15) attached to the upper hole in the Front Upright (42). See the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the M10 Nylon Locknut (21) and the M10 x 95mm Bolt (71).

23.Attach the end of the Short Cable (58) to the Long “U”-Bracket (57) with an M8 Nylon Locknut

(3) and an M8 Washer (8). See the inset draw- ing. Do not overtighten the Nylon Locknut; it should be threaded onto the end of the Cable so only a couple of threads are showing above the nut.

22

42

 

15

 

71

 

66

 

58

 

Inset shows view

 

from other side

 

58

42

15

21

 

23

 

 

3

 

57

 

8

 

58

 

3

 

8

57

58

12

Image 12
Contents QUESTIONS? Model No. WESY19511 Serial NoTable of Contents Important Precautions DecalUsing the Weider 8525 weight system. If you have Before YOU BeginFor your benefit, read this manual carefully before Right SideAssembly Frame AssemblyMake Things Easier for Yourself Weights Do not tighten the Nylon Locknuts yetTighten the Nylon Locknuts used in steps Arm Assembly Weight Guides are at the top, as shownArm. Arm identification is very important for Step Ful not to confuse the Right Arm with the LeftArm 47 refer to to identify the Right Cable Assembly Cable Trap is positioned to hold the Cable in placeThat the Cable Trap is inside the U-Bracket Locate the Short Cable 58. Lay the Short Inset shows viewFrom other side Inset shows view Seat Assembly Page Page Adjustments Changing the Weight SettingAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart Troubleshooting and Maintenance Tightening the CablesCable Diagram Long Cable 23 TOP ViewShort Cable Page Part LIST-Model No. WESY19511 Key No. Qty DescriptionExploded DRAWING-Model No. WESY19511 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part Identification Chart from the Manual Part Identification CHART-Model No. WESY19511 R0802B Page 50mm Square Outer Cap