29.Press a 19mm Round Inner Cap (34) into each end of both Pad Tubes (28).
Insert one Pad Tube (28) into the Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube.
Insert the other Pad Tube (28) into the Leg Lever (29). Slide a Foam Pad (30) onto each end of the Pad Tube.
30.Attach the Preacher Pad (79) to the Preacher Post (78) with two M6 x 16mm Screws (18).
29 |
36 |
30 |
34 |
28 |
34 |
30 |
29 |
30 |
79 |
78 |
18 |
31.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 20 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables; see
15