Weider WESY19511 Do not tighten the Nylon Locknuts yet, Tighten the Nylon Locknuts used in steps

2.Slide the Front Upright (42) onto the M8 x 63mm Carriage Bolts (1) in the Base (4). Hand tighten an M8 Nylon Locknut (3) onto each Carriage Bolt.

Do not tighten the Nylon Locknuts yet.

Press a 25mm Square Inner Cap (65) into the Front Upright (42).

3.Press a 50mm Square Inner Cap (27) into each end of the Top Frame (55). Press a 38mm Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press two 25mm Round Inner Caps (49) into the top of the crossbar.

Attach the Top Frame (55) to the Front Upright

(42)and the Rear Upright (56) with four M8 x 65mm Bolts (11), four M8 Washers (8), and four M8 Nylon Locknuts (3).

Tighten the Nylon Locknuts used in steps 1–3.

4.Set two Weight Bumpers (19) onto the bracket on the Base (4) as shown.

Stack the six Weights (25) on the Weight Bumpers (19). Be sure that all of the Weights are turned so the large pin grooves are on the bottom of the Weights and on the same side of the weight stack. Be careful not to tip the stack of

Weights.

2
		42
			65
		3
			4
		1
3	11
		11
27	8	8
			44
	55		27
			49
	44	Crossbar
3
56	3	42
4
		25
			Pin Groove
19
	4
	Bracket

6