Weider WESY19511 user manual Remove this Part Identification Chart from the Manual

Page 25

REMOVE THIS PART IDENTIFICATION

CHART FROM THE MANUAL

This chart is provided to help you identify the small parts used in assembly. Important: Some parts may have been pre-assembled for shipping purposes; if you cannot find a part in the parts bags, check to see if it has been pre-assembled.

Note: The assembly procedure is divided into four stages: 1) frame assembly, 2) arm assembly, 3) cable assembly, and 4) seat assembly. The hardware for each stage is packaged separately. Wait until you begin each assembly stage to open that parts bag.

Image 25

Contents Model No. WESY19511 Serial No QUESTIONS?Table of Contents Decal Important PrecautionsBefore YOU Begin Using the Weider 8525 weight system. If you haveFor your benefit, read this manual carefully before Right SideFrame Assembly AssemblyMake Things Easier for Yourself Do not tighten the Nylon Locknuts yet WeightsTighten the Nylon Locknuts used in steps Weight Guides are at the top, as shown Arm AssemblyFul not to confuse the Right Arm with the Left Arm. Arm identification is very important for StepArm 47 refer to to identify the Right Cable Trap is positioned to hold the Cable in place Cable AssemblyThat the Cable Trap is inside the U-Bracket Inset shows view Locate the Short Cable 58. Lay the ShortFrom other side Inset shows view Seat Assembly Page Page Changing the Weight Setting AdjustmentsAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart Tightening the Cables Troubleshooting and MaintenanceLong Cable 23 TOP View Cable DiagramShort Cable Page Key No. Qty Description Part LIST-Model No. WESY19511Exploded DRAWING-Model No. WESY19511 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part Identification Chart from the Manual Part Identification CHART-Model No. WESY19511 R0802B Page 50mm Square Outer Cap