5.Press the Weight Tube Bumper (64) into the end of the Weight Tube (63). Insert the Weight Tube into the stack of Weights (25). Be sure that the pins on the Weight Tube are resting in the pin grooves in the upper Weight.
Lubricate the insides of the holes in the Top Weight (76). Set the Top Weight onto the stack of Weights (25).
Insert both Weight Guides (62) into the stack of Weights (25). Be sure that the holes in the
Weight Guides are at the top, as shown.
6.Attach the upper ends of the Weight Guides (62) to the Top Frame (55) with the M8 x 150mm Bolt (60), two 13mm x 19mm Spacers (61), and an M8 Nylon Locknut (3).
Be sure that the Pulley Bracket (20) is in front of the right Weight Guide (62) as shown.
Arm Assembly
7.Press a 25mm x 22mm Plastic Bushing (75) onto each welded spacer on the Press Frame (17). Slide the Press Frame into place on the Base (4).
Note: This will be a tight fit. The Plastic Bushings should fit onto each end of the indi- cated tube in the Base. Be sure that the 90mm Pulley (15) is on the indicated side.
Lubricate the M10 x 195mm Bolt (59). Attach the Press Frame (17) to the Base (4) with the Bolt and an M10 Nylon Locknut (21). Do not over- tighten the Locknut; the Press Frame must be able to pivot freely.
5 |
|
|
|
| Holes |
|
| 62 |
| 76 |
|
|
| Lubricate |
|
| 63 |
|
| 64 |
| Pin Groove |
|
| 25 |
|
6 | 61 |
|
| 3 | |
|
| |
|
| 55 |
| 60 | 20 |
|
| 62 |
7 |
|
|
|
| 15 |
|
| 17 |
|
| Lubricate |
| 21 | 59 |
| 4 | Welded |
|
| |
| Tube | Spacers |
|
| 75 |
7