JVC CA-HXZ3 Setting the Clock, Adjusting the Volume, Press CLOCK/TIMER, Turn 4 / ¢ to adjust the

Page 15
Setting the Clock

Continued

Setting the Clock

Adjusting the Volume

 

 

 

English

You can set the clock whether the unit is on or off; however, if Ecology Mode is activated, you cannot set the clock while the unit is off (on standby).

If Ecology Mode is not in use while the unit is turned off (on standby), “0:00” flashes on the display until you set the clock.

On the unit ONLY:

1 Press CLOCK/TIMER.

/ TIMER

 

CLOCK

The hour digits start flashing on the display.

2 Turn 4 / ¢ to adjust the

 

E

hour, then press SET/DISPLAY.

 

PR SET

 

 

The minute digits start flashing on the display.

If you want to correct the hour

 

SET /

CANCEL / DEMO

DISPLAY

 

after pressing SET/DISPLAY,

 

 

press CANCEL/DEMO.

 

 

The hour digits start flashing again.

 

3 Turn 4 / ¢ to adjust the minute, then press SET/DISPLAY.

To check the clock time while playing a source

Press and hold SET/DISPLAY.

Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have set the clock before, press CLOCK/TIMER repeatedly until the clock setting mode is selected.

Each time you press the button, the clock/timer setting modes change as follows:

DAILY Adjusting the Volume TIMER 1 Press CLOCK/TIMER. REC

(Daily Timer setting)

Canceled

 

 

Clock

 

 

TIMER

 

 

 

 

 

setting

(Recording Timer setting)

 

 

 

 

 

 

 

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs

The clock loses the setting and is reset to “0:00.” If this happens, set the clock again.

You can adjust the volume level only while the unit is turned on. The volume level can be adjusted in 32 steps (VOLUME MIN, VOLUME 1 – VOLUME 30, and VOLUME MAX).

Turn VOLUME + / – clockwise (+)

V

ME

 

U

 

L

 

 

O

 

to increase the volume or counterclockwise (–) to decrease it.

When using the remote control, press

VOLUME + to increase the volume or

VOLUME – to decrease it.

VOLUME

2 Turn 4 / ¢ to adjust thehour, then press SET/DISPLAY. For private listening

Connect a pair of headphones to the PHONES ( To check the clock time while playing a source ) jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones.

DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, a sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source next time. REMEMBER, you cannot adjust the volume level while the unit is off (on standby).

To turn down the volume level temporarily

On the remote control ONLY:

Press FADE MUTING.

FADE

 

MUTING

The volume level gradually decreases to “VOLUME MIN.”

To restore the sound, press the button again.

– 10 –

Image 15
Contents For Customer Use CA-HXZ3COMPACT COMPONENT SYSTEM INSTRUCTIONSG-1 Warnings, Cautions and OthersAvisos, precauciones y otras notas Advertências, precauções e outras notasPRECAUÇÃO G-2English Español Português PRECAUCIÓNPrecaução Ventilação adequada G-3Caution Proper Ventilation Precaución El aparato debe estar bien ventiladoIMPORTANT FOR LASER PRODUCTS G-4English Español PortuguêsIntroduction PrecautionsInstallation Power sourcesEnglish ContentsEnglish Location of the Buttons and ControlsFront Panel Front PanelFront Panel Display WindowPressing this button also turns on the unit EnglishRemote Control Remote ControlEnglish Getting Started Supplied AccessoriesConnecting Antennas Putting the Batteries into the Remote Control2Insert the end of the speaker cord into the Connecting SpeakersAM antenna To connect an outdoor AM antennaTo connect an analog component Connecting Other EquipmentAdjusting the Voltage Selector Canceling the DemonstrationEcologyMode Turning On or Off the PowerOn the remote control ONLY Common Operations2 Turn 4 / ¢ to adjust the Setting the ClockAdjusting the Volume 1 Press CLOCK/TIMERTo select the sound modes, turn on the remote control until the sound modeReinforcing the Bass Sound Selecting the Sound Modes6 Press SET/DISPLAY again Setting the AM Tuner Interval Spacing1 Select one of the preset sound modes Creating Your Own Sound Mode-UserMode1 Tune in to the station you want to preset Tuning in to a StationTuning in to a Preset Station Presetting StationsWhen and why they go off? When playing a CD-Ror CD-RWWhat is MP3? When and why they light up?English How are MP3 files recorded and played back?7For audio CDs Playing Back DiscsLoading Discs Playing Back the Entire Discs-ContinuousPlayTo exchange discs during playback of another Basic Disc Operations3 Select a track to start playing with Disc playback sequenceSET/DISPLAY 4 Select a track from the selecteddisc in step Turn 4 / ¢ to select the track number, then pressTo modify the program To check the program contentsPlaying at Random-RandomPlay 1 Load a discFor MP3 discs Repeating Tracks or Discs-RepeatPlayProhibiting Disc Ejection-TrayLock For audio CDsClose the cassette holder gently Playing Back TapesLocating the Beginning of a Song-MusicScan 1 Press 0 EJECT for the cassette deck2 Close the cassette holder gently To clean the heads, capstans, and pinch rollersRecording Recording on a TapeLoad a disc Select a disc Synchronized Recording7Direct Recording 4 Press CD REC STARTLoad a disc button where a disc is loadedthe Reverse Mode indicator lights up like 7Auto Edit Recording only for audio CDs1 Turn MIC LEVEL to MIN 3 Press KARAOKE on the remote controlSinging along-Karaoke 7Vocal Masking2 Press CLOCK/TIMER again Using the TimersUsing Daily Timer How Daily Timer actually worksthe Daily Timer setting 6 When selecting “TUNER FM” or “TUNERAM”When selecting “1 CD--1” volume level3 Press CLOCK/TIMER again Using Recording TimerHow Recording Timer actually works 2 Press CLOCK/TIMER2 To turn off the Recording Timer, press Using Sleep TimerTimer Priority How Sleep Timer actually worksHandling discs MaintenanceCleaning the unit To clean the discCause TroubleshootingSymptom EnglishTuner SpecificationsSupplied accessories Amplifier sectionMEMO MEMO EN, SP, PR IMPORTANT for mains AC lineIMPORTANTE para la línea de la red CA IMPORTANTE para a ligação à tensão da rede CADemonstração DemonstrationEspañol Demostración