JVC CA-HXZ3 Using the Timers, Using Daily Timer, How Daily Timer actually works, Before you start

Using the Timers

There are three timers available—DAILY (Daily Timer), REC (Recording Timer), and SLEEP (Sleep Timer).

You can set the timers whether the unit is on or off; however, if Ecology Mode is activated, you cannot set the timers while the unit is off.

Before using the timers, set the clock built in the unit. (See page 10.)

Using Daily Timer

With Daily Timer, you can be wake up with your favorite music or radio program.

How Daily Timer actually works

The unit automatically turns on, sets the volume level to the preset level, and starts playing the specified source when the on-time comes. (“DAILY” and the DAILY indicator flash just before the on-time, and the DAILY indicator continues flashing while the timer is operating.) Then, when the off- time comes (“DAILY OFF” flashes just before the off-time), the unit automatically turns off (on standby).

The Daily Timer works everyday automatically. If you do not want to use the Daily Timer, turn it off. (See “To turn on or off Daily Timer after its setting is done” on page 27.) The timer setting remains in memory until you change it.

	Continued
On the unit ONLY:
1 Press CLOCK/TIMER	/ TIMER
	CLOCK
repeatedly until “DAILY”
appears on the display.

The (Timer) indicator lights up and the DAILY (Daily Timer) indicator also starts flashing on the display.

D A I L Y

•Each time you press the button, the timer setting modes change as follows:

		DAILY		TIMER		REC
			(Daily Timer setting)
	Canceled			Clock		TIMER
				setting	(Recording Timer setting)
		(The hour digits start flashing.)
2 Press CLOCK/TIMER again.							/ TIMER
							CLOCK

“TIMER” appears for 2 seconds, then the unit enters on-time setting mode.

D A I L Y

English

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•To correct a misentry while setting the timer, press

CANCEL/DEMO.

Before you start...

• When using a disc as the source to play—

– Make sure there is a disc on the selected disc tray.

• When using a tape as the source to play—

– Make sure that a tape is in the cassette deck.

– Make sure that the tape direction is correct.

• When using the external component as the source to

3 Set the on-time you want the unit to turn on at.

1)Turn 4 / ¢ to set the hour, then press SET/DISPLAY.

“SET” appears for 1 second.

2)Turn 4 / ¢ to set the minute, then press SET/DISPLAY. “SET” appears for 1 second, then the unit enters off-time setting mode.

PR	E
	SET

SET /

DISPLAY

play—

– Set the timer equipped on the external component at

the same time.

D A I L Y

– 26 –