JVC CA-HXZ3 Using Recording Timer, How Recording Timer actually works, Press CLOCK/TIMER, English

Page 33
Using Recording Timer

Continued

English

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

How Recording Timer actually works

The unit automatically turns on, tunes in to the specified station, sets the volume level to “VOLUME MIN,” and starts recording when the on-time comes (“REC” and the REC indicator flash just before the on-time, and the REC indicator continues flashing while the timer is operating). Then, when the off-time comes (“REC OFF” flashes just before the off- time), the unit automatically turns off (on standby).

The timer setting remains in memory until you change it.

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

To correct a misentry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Insert a recordable cassette with the exposed part of the tape down.

2 Press CLOCK/TIMER

/ TIMER

 

CLOCK

repeatedly until “REC”

 

appears on the display.

 

The How Recording Timer actually works (Timer) indicator lights up and the REC (Recording Timer) indicator also starts flashing on the display.

2 Press CLOCK/TIMER R E C repeatedly until “REC”

Each time you press the button, the timer setting modes change as follows:

 

 

 

DAILY

 

 

 

TIMER

 

 

 

 

REC

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(Daily Timer setting)

 

 

 

 

 

Canceled

 

 

Clock

 

 

 

 

TIMER

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

setting

(Recording Timer setting)

 

 

 

 

(The hour digits start flashing.)

 

3 Press CLOCK/TIMER again.

/ TIMER

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CLOCK

“TIMER” appears for 2 seconds, then the unit enters on-time setting mode.

3 Press CLOCK/TIMER again. R E C 4 Set the on-time you want the

4 Set the on-time you want the

E

PR SET

 

unit to turn on at.

 

1)

Turn 4 / ¢ to set the hour, then

 

 

press SET/DISPLAY.

 

 

“SET” appears for 1 second.

 

2)

Turn 4 / ¢ to set the minute,

 

 

then press SET/DISPLAY.

 

 

“SET” appears for 1 second, then

 

 

the unit enters off-time setting mode.

DISPLAY

 

 

SET /

unit to turn on at. R E C 6 Select the preset station.

5 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4 / ¢ to set the hour, then press

SET/DISPLAY.

“SET” appears for 1 second.

2)Turn 4 / ¢ to set the minute, then press

SET/DISPLAY.

“SET” appears for 1 second, then the unit enters preset station selecting mode.

6 Select the preset station.

1)Turn 4 / ¢ to select the band (“TUNER FM” or “TUNER AM”), then press SET/DISPLAY.

“SET” appears for 1 second.

2)Turn 4 / ¢ to select a preset channel number, then press SET/DISPLAY.

The REC (Recording Timer) indicator stops flashing and remains lit. “OK – 28 –” appears on the display for 2 seconds.

The settings you have done are shown on the display in sequence for your confirmation.

7 Press Manual background to turn off the unit (on standby) if necessary.

If you want to listen to another source while recording Press REC START/STOP or 7 to stop recording. Without stopping it, you cannot change the source.

Even if you unplug the AC power cord or if a power failure occurs

Once you set the timer, the timer setting may remain stored in memory for a few days. In this case, check whether the timer setting still remains or not.

– 28 –

Image 33
Contents COMPACT COMPONENT SYSTEM CA-HXZ3INSTRUCTIONS For Customer UseAvisos, precauciones y otras notas Warnings, Cautions and OthersAdvertências, precauções e outras notas G-1English Español Português G-2PRECAUCIÓN PRECAUÇÃOCaution Proper Ventilation G-3Precaución El aparato debe estar bien ventilado Precaução Ventilação adequadaEnglish Español G-4Português IMPORTANT FOR LASER PRODUCTSInstallation PrecautionsPower sources IntroductionEnglish ContentsFront Panel Location of the Buttons and ControlsFront Panel EnglishPressing this button also turns on the unit Display WindowEnglish Front PanelRemote Control Remote ControlEnglish Connecting Antennas Supplied AccessoriesPutting the Batteries into the Remote Control Getting StartedAM antenna Connecting SpeakersTo connect an outdoor AM antenna 2Insert the end of the speaker cord into theAdjusting the Voltage Selector Connecting Other EquipmentCanceling the Demonstration To connect an analog componentOn the remote control ONLY Turning On or Off the PowerCommon Operations EcologyModeAdjusting the Volume Setting the Clock1 Press CLOCK/TIMER 2 Turn 4 / ¢ to adjust theReinforcing the Bass Sound on the remote control until the sound modeSelecting the Sound Modes To select the sound modes, turn1 Select one of the preset sound modes Setting the AM Tuner Interval SpacingCreating Your Own Sound Mode-UserMode 6 Press SET/DISPLAY againTuning in to a Preset Station Tuning in to a StationPresetting Stations 1 Tune in to the station you want to presetWhat is MP3? When playing a CD-Ror CD-RWWhen and why they light up? When and why they go off?English How are MP3 files recorded and played back?Loading Discs Playing Back DiscsPlaying Back the Entire Discs-ContinuousPlay 7For audio CDs3 Select a track to start playing with Basic Disc OperationsDisc playback sequence To exchange discs during playback of anotherdisc in step 4 Select a track from the selectedTurn 4 / ¢ to select the track number, then press SET/DISPLAYPlaying at Random-RandomPlay To check the program contents1 Load a disc To modify the programProhibiting Disc Ejection-TrayLock Repeating Tracks or Discs-RepeatPlayFor audio CDs For MP3 discsLocating the Beginning of a Song-MusicScan Playing Back Tapes1 Press 0 EJECT for the cassette deck Close the cassette holder gentlyRecording To clean the heads, capstans, and pinch rollersRecording on a Tape 2 Close the cassette holder gently7Direct Recording Synchronized Recording4 Press CD REC START Load a disc Select a discthe Reverse Mode indicator lights up like button where a disc is loaded7Auto Edit Recording only for audio CDs Load a discSinging along-Karaoke 3 Press KARAOKE on the remote control7Vocal Masking 1 Turn MIC LEVEL to MINUsing Daily Timer Using the TimersHow Daily Timer actually works 2 Press CLOCK/TIMER againWhen selecting “1 CD--1” 6 When selecting “TUNER FM” or “TUNERAM”volume level the Daily Timer settingHow Recording Timer actually works Using Recording Timer2 Press CLOCK/TIMER 3 Press CLOCK/TIMER againTimer Priority Using Sleep TimerHow Sleep Timer actually works 2 To turn off the Recording Timer, pressCleaning the unit MaintenanceTo clean the disc Handling discsSymptom TroubleshootingEnglish CauseSupplied accessories SpecificationsAmplifier section TunerMEMO MEMO IMPORTANTE para la línea de la red CA IMPORTANT for mains AC lineIMPORTANTE para a ligação à tensão da rede CA EN, SP, PREspañol DemonstrationDemostración Demonstração