Weider WEBE29910 user manual See the inset drawing. Slide a Cable Ball

26. Wrap the High Cable (61) around an 88mm	26
Pulley (36). Attach the Pulley and a Small Cable		77
Trap (93) to the Left Frame (6) with an M10 x
45mm Bolt (76) and an M10 Nylon Locknut (77).					93
			6	36	76
				61
27. Wrap the High Cable (61) around a 4 1/2” Pulley	27
(35). Attach the Pulley and a Large Cable Trap
(55) to the “U”-Bracket (33) with an M10 x 45mm		35	61
Bolt (76) and an M10 Nylon Locknut (77).
	55			77
	76		33
28. Wrap the High Cable (61) around an 88mm	28			76
Pulley (36). Attach the Pulley and a Small Cable
Trap (93) to the Right Frame (5) with an M10 x		61		93
45mm Bolt (76) and an M10 Nylon Locknut (77).
				36
	5	77
29. Route the High Cable (61) through the tube on	29
the right Pulley Arm (7). Wrap the Cable around a
				Tube
4 1/2” Pulley (35). Attach the Pulley to the Pulley		77			61
Arm with an M10 x 45mm Bolt (76) and an M10		7
Nylon Locknut (77).
See the inset drawing. Slide a Cable Ball (56)	61
onto the end of the High Cable (61). Thread an			35
M6 Locknut (80) onto the Cable as far as it will	56
go. Tighten a Cable Eye (57) onto the Cable.	80
Hold the Cable Eye and fully tighten the Locknut
		76
against the Cable Eye. Slide the Cable Ball over
the Locknut and the Cable Eye.	57
30. Locate the Carriage Cable (60). Attach the end	30
of the Cable inside the Top Frame (9) with an
		79
M10 x 75mm Bolt (73), two 27mm Spacers (94),			94	9
two M10 Washers (79), and an M10 Nylon		77
				94
Locknut (77).					79
					73
				60
	13