Troubleshooting and Maintenance

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened.

Slack can be removed by moving a Pulley (39) and Cable Trap (41) to a set of holes closer to the center of the two Pulley Plates (14). Remove the M10 Nylon Locknut (56) and the M10 x 48mm Bolt (77) from the Cable Trap, the Pulley, and the Pulley Plates. Re- attach the Pulley and the Cable Trap to the new set of holes in the Pulley Plates with the Bolt and Nylon Locknut. Make sure that the Cable Trap is in the proper position and that the Cable and Pulley move smoothly.

Slack can also be removed by moving the Pulley (39) and the Cable Trap (41) to the higher set of holes in a “U”-Bracket (81). Remove the M10 Nylon Locknut (56) and the M10 x 48mm Bolt (77) from the Cable Trap, the Pulley, and the “U”-Bracket. Re-attach the Pulley and the Cable Trap to the higher set of holes in the “U”-Bracket with the Bolt and Locknut.Make sure that the Cable Trap is in the proper position and that the Cable and Pulley move smoothly.

Slack can also be removed from the cables by tighten- ing the M8 Nylon Locknut (61) attaching the Short Cable (80) to the “U”-Bracket (81). To do this, you may need to remove the Pulley (39) from the “U”-Bracket.

Make sure that the cables are not too tight, or the Weight Carriage (26) will be lifted.

39	41
39
	56
77	14
	56
	41
77	39
80
76	81 56
61	41
	41
77	26
77	39