Weider WESY2916.0 Frame Assembly, Nylon Locknuts yet, End of the Leg Lever Bumper is pointing up

Frame Assembly	1
1.
Before beginning assembly, make sure you
understand the information in the box on
page 8. See the PART IDENTIFICATION
CHARTS on pages 5 and 6 for help identify-			1	83
ing small parts.
Insert four M8 x 75mm Carriage Bolts (83) up		83
through the Base (1). Note: It may be helpful to
place a piece of tape over each Bolt head to	2
hold it in place.
2. Insert an M8 x 75mm Carriage Bolt (83) up
through the Stabilizer (3).
Attach the Base (1) and the two Weight Guides
(18) to the Stabilizer (3) with two M10 x 85mm
Bolts (81), two M10 Washers (80), two 21mm
Steel Spacers (108) and two M10 Nylon Locknuts
(77), and an M8 Nylon Locknut (78). Make sure
the indicated holes in the Weight Guides are
nearer the bottom. Do not tighten the Nylon
Locknuts.
Attach the Upright (2) to the Base (1) with the two
indicated M8 x 75mm Carriage Bolts (83) and two		18
M8 Nylon Locknuts (78). Do not tighten the
Nylon Locknuts yet.
		Holes		81
		78	80
	2
		77		80
		78
	78		83	3
			108
		1
		83
3. Attach the Front Leg (10) to the Base (1) with the	3
two M8 x 75mm Carriage Bolts (83) and two M8
Nylon Locknuts (78). Do not tighten the Nylon		75	10
Locknuts yet.
		104
Attach the Leg Lever Bumper (75) to the Front		110	78
Leg (10) with an M4 x 16mm Self-tapping Screw
(110) and an M4 Washer (104). Make sure the		78
end of the Leg Lever Bumper is pointing up.
			83
			1
	9