Weider WESY92190 manual

22.Remove the 3 1/2Ó Pulley (35) from the pre-assem- bled Adjustment Bracket (84). Wrap the High Cable

(2) around the Pulley in the direction shown. Attach the Pulley to the Bracket with a 3/8Ó x 1 1/2Ó Bolt (60) and a 3/8Ó Nylon Jamnut (63).

23.Wrap the High Cable (2) around a 3 1/2Ó Pulley (35) Pulley in the direction shown.

Attach the Pulley (35) and two Pulley Covers (32) to the bushing below the welded hook on the Front Upright (42) with a 3/8Ó x 4 1/2Ó Bolt (93), two 3/8Ó Flat Washers (55), and a 3/8Ó Nylon Jamnut (63).

Make sure the parts are assembled exactly as shown in the inset drawing.

24.Locate the Low Cable (9). Wrap the end with the ball around the Low Pulley (40) in the direction shown. Attach the Low Pulley to the welded bracket on the Base (8) with a 3/8Ó x 1 1/2Ó Bolt (60) and a 3/8Ó Nylon Jamnut (63).

Thread the Low Cable (9) through the Press Frame (12). Wrap the Low Cable around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley to the Front Upright (42) with a 3/8Ó x 3 3/4Ó Bolt (19), a Cable Trap (66), a 3/8Ó Flat Washer (55), and a 3/8Ó Nylon Jamnut (63).

Make sure the Cable Trap (66) is positioned as shown and that the Pulley (35) is not rubbing on the Cable Trap.

25.Remove the pre-assembled 3 1/2Ó Pulley (35) attached to the Pulley Plates (31). Wrap the Low Cable (9) around the Pulley in the direction shown.

Re-attach the Pulley (35) and a Cable Trap (66) to the lowest holes in the Pulley Plates (31) with a 3/8Ó x 1 1/2Ó Bolt (60) and the 3/8Ó Nylon Jamnut (63).

22
					63
	60				2
					35
			84
23
			63
Small	55
Tabs			32		55
			35	32
			2
			42		93
24
42		63
	55
66			8
					40
19	35				9
		12
			Welded		63
			Bracket
			60
25
			31
			66
		63
			35		60
			9

12