Weider WESY92190 manual Cable Assembly

Cable Assembly

15.Open the parts bag labeled ÒCABLE ASSEMBLY AND PULLEYS.Ó For Cable identification and rout- ing during steps 15Ð30, refer to the Cable Diagram and Cable ID Chart on page 19.

Identify the High Cable (2). It is approximately 163 1/2Ó long. It is the shortest cable and it has a ball on each end. Wrap the end with the small ball around a 3 1/2Ó Pulley (35) in the direction shown.

Attach the Pulley (35) to the Top Frame (1) with a 3/8Ó x 3 1/2Ó Bolt (54), a 3/8Ó Flat Washer (55) and a 3/8Ó Nylon Jamnut (63).

Make sure the High Cable (2) is between the Pulley (35) and the welded hook on the Top Frame

(1).

16.Wrap the High Cable (2) around a ÒVÓ-Pulley (6) in the direction shown.

Attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50) to the indicated bracket with a 3/8Ó x 2 1/4Ó Bolt (65) and a 3/8Ó Nylon Locknut (57). Make sure the Long

Cable Trap is positioned as shown, so it will hold the Cable in place.

17.Wrap the High Cable (2) around a ÒVÓ-Pulley (6) in the direction shown.

Attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50) to the Left Butterfly Arm (47) with a 3/8Ó x 2 1/2Ó Bolt (96) and a 3/8Ó Nylon Locknut (57).

Make sure the Long Cable Trap (50) is positioned as shown. It may be helpful to take the Butterfly Arm (47) through one full range of motion to ensure that the Cable Trap does not rub on the cable.

Route the High Cable (2) under the Top Frame (1) between the ÒVÓ-Pulley (6) and the crossbar.

10

15
		63	1
55
		Hook
		35
			54
			2
16	Welded
	Bracket
2
			65
			50
			6
			57
17			1
	2	50	96
Crossbar		6
		57	47