Frame Assembly
1.Before beginning assembly, make sure you have read and understood the information on page 5.
Open the parts bag labeled ÒFRAME ASSEMBLY.Ó
Press a 2Ó Square Outer Cap (51) onto each end of the Stabilizer (5).
Insert two 5/16Ó x 2 3/4Ó Carriage Bolts (14) up through the Stabilizer (5) and place it flat on the floor.
2.Press a 2Ó Square Inner Cap (21) into the end of the Base (8).
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (52) up through the Base (8).
Place the Base (8) on the floor with the holes in the mounting bracket over the Carriage Bolts (14) in the Stabilizer (5).
3.Press a 1Ó x 2Ó Inner Cap (11) into the top of the Rear Upright (18).
Slide the Rear Upright (18) onto the 5/16Ó x 2 3/4Ó Carriage Bolts (14) in the Stabilizer (5). Hand tighten a 5/16Ó Nylon Locknut (53) onto each Carriage Bolt.
Make sure the Rear Upright (18) is oriented as shown. The wide side of the bracket on the lower end must be on the side shown.
Slide the Front Upright (42) onto the 5/16Ó x 2 1/2Ó Carriage Bolts (52) in the Base (8). Hand tighten a 5/16Ó Nylon Locknut (53) onto each Carriage Bolt.
Do not tighten the Nylon Locknuts yet.
1 |
|
|
|
|
| 5 | 51 |
|
|
| |
| 51 |
| 14 |
|
|
| |
2 |
| Bracket |
|
|
|
| |
14 |
|
| 8 |
|
| 52 |
|
5 |
|
|
|
|
|
| 21 |
3 |
|
|
|
11 |
|
|
|
18 |
|
| 42 |
Wide | 53 | 53 |
|
|
| ||
|
|
| |
Side of |
|
|
|
the |
|
|
|
Bracket |
|
| 53 |
|
|
| |
5 |
| 53 |
|
|
|
| |
|
| 14 | 8 |
|
|
| |
|
| 52 |
|
6