Weider WESY92190 manual Power

Page 18

39.Note: The console cord should be positioned between the two bottom screws on the Shroud. Align the Right Shroud (79) with the holes in the Top Frame (1), the Base (8), and the two Uprights (18, 42 [not shown]) and attach it with 14 #8 x 3/4Ó Tap Screws (80).

See the inset drawing. Attach the power cord jack to the inside of the Right Shroud (79) with two #8 x 1/2Ó Screws (87).

40.Align the Left Shroud (78) with the holes in the Top Frame (1), the Base (8), and the two Uprights (18,

42) and attach it with 14 #8 x 3/4Ó Tap Screws (80).

41.Make sure that all parts have been properly tight- ened. The use of the remaining parts will be explained in HOW TO USE THE WEIGHT SYSTEM, beginning on page 20 of this manual.

Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT:

If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-SHOOTING AND MAINTENANCE on page 21.

18

39

 

 

1

 

 

 

 

79

 

 

80

 

 

18

 

80

 

 

80

 

 

 

 

80

 

 

87

80

 

 

Power

 

 

Cord

8

 

 

Jack

 

 

 

 

 

 

Console

 

80

 

Cord

40

 

18

78

1

 

 

80

 

80

42

 

 

80

 

80

 

80

8

80

80

Image 18
Contents QUESTIONS? Model No. WESY92190 Serial NoTable of Contents Important Precautions Before You Begin DecalAssembly Frame Assembly Do not tighten the Nylon Locknuts yetTighten all of the Nylon Locknuts used in steps 3 to Open the parts bag labeled Òarm ASSEMBLY.Ó Support Plate 27 is oriented as shownCap is angled as shown in the inset drawing Nylon Jamnut. The Leg Lever should pivot freely LeftRight Cable Assembly Page Page Tube Seat Assembly Open the parts bag labeled Òseat ASSEMBLY.ÓPage Page Screw must pivot freely Power Cable Diagram Cable ID Chart Low CableHigh Cable How to Use the Weight System Plugging in the Power CordUsing the Curl Post Trouble-shooting and Maintenance Tightening the CablesPage Part Identification ChartÑWESY92190 Page Part ListÑModel No. WESY92190 Qty DescriptionExploded Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT