Screw must pivot freely | Weider WESY92190 specification

38d.Set the console to 150 pounds as shown in the inset drawing. This will begin to move the Weight Mechanism (26) down.

38e.See the inset drawing. Loosen the 3/8Ó Plain Nuts (85), and the 3/8Ó x 3Ó Bolt (88) so that the 3/8Ó x 4Ó Tap Screw (86) can rotate freely. Note: The Tap

Screw must pivot freely.

38f. Check the brass piece that is pictured in drawing 38f. It should barely be touching the shaded area on the Weight Mechanism (26) and should move slightly from side to side.

If the brass piece is too loose, there will be a noticeable time lapse between the time an exer- cise is started and the time resistance is felt. If the brass piece is too tight, the Weight Mechan- ism (26) will have difficulty moving and may become jammed so that no movement can occur.

38g.If the brass piece is too loose, tighten the 3/8Ó Tap Screw (86) 1/4 turn. If the brass piece is too tight, loosen the Screw 1/4 turn.

Re-check the clearance between the brass piece and the Weight Mechanism (26) after each adjustment until the brass piece is barely touching the shaded area on the Mechanism. It should move slightly from side to side.

Begin decreasing the resistance on the console. If the motor stalls or hesitates, loosen the 3/8Ó Tap Screw (86) 1/4 turn. Continue to decrease the resis- tance until the console is at its lowest weight reading (L30) and the brass piece moves slightly from side to side. When the lowest setting is reached, leave the 3/8Ó Tap Screw (86) stationary and tighten the 3/8Ó Plain Nuts (85) and the 3/8Ó x 3Ó Bolt (88).

Disconnect the Power Adapter Cord (connected in step 37) from the wire bundle.

38d

	26
38e
	88
	85
	86
85	85 86
38f

Brass

Piece

38g