Weider WESY78734 user manual Do not tighten the Screw yet, Tighten the 1/2 x 25mm Screw

2. Insert the connector of the Upper Wire Harness	2
(71) into the socket of the Lower Wire Harness
			6	12
(143). The connector should slide easily into
the socket and snap into place. If the connector				85
does not slide easily and snap into place, turn it
over and then insert it.
Make sure that the connector and wires appear
as shown in the inset drawing. IF THE CONNEC-				143
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER		71
IS TURNED ON.
Insert the Mech Frame (6) into the Base Plate (1).
Attach the Mech Frame to the Upright (2) with a
1/2” x 25mm Screw (85) and a 1/2” Lock Washer
(12). Do not tighten the Screw yet.		103
Attach the Mech Frame (6) to the Base Plate (1)				Black
with four M10 Nylon Locknuts (103).		2
				Wire
			1
Tighten the 1/2” x 25mm Screw (85).
					143
			103
					Red
				71
					Wire
3. Press the Rail Cap (49) onto the Leg (5). Attach	3
the Leg to the Rail (4) with two M10 x 64mm
Button Bolts (80), four M10 Washers (106), and		103
two M10 Nylon Locknuts (103).
		106	4
				Holes on
				this side
		49		106
				80
		5
4. Lubricate an M10 x 125mm Button Bolt (89) with	4		29
grease. Attach the Rail (4) to the Row Plate (28)
with the Bolt, two M10 Washers (106), two 31mm
Spacers (30), and an M10 Nylon Locknut (103).				28
Do not overtighten the Locknut; the Rail must	103	106
be able to pivot easily.
Tighten the Storage Knob (29) into the Row Plate	30
(28) and the Rail (4).
		4	30	106	89
				Lubricate
	7