Weider WESY78734 user manual Push the excess Upper Wire Harness 71 into the Upright

5.Insert the Squat Pin (66) into the Upright (2). Slide the Squat Carriage (19) onto the Upright (2).

6.Attach the Top Frame (37) to the Upright (2) with two M10 x 25mm Button Screws (88), an M10 x 75mm Button Screw (84), three M10 Lock Washers (75), and an M10 Washer (106).

7.Pull the excess Upper Wire Harness (71) out of the Upright (2). Insert the connector on the Console (67) into the socket on the Upper Wire Harness. The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn it over and then insert it.

Make sure that the connector and wires appear as shown in the inset drawing. IF THE CONNEC-

TOR IS NOT INSERTED PROPERLY, THE CON- SOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

Push the excess Upper Wire Harness (71) into the Upright (2).

Attach the Console (67) to the Upright (2) with four M4 x 70mm Screws (114).

5
		2
		19
		66
6
		88
	37	75
			84
		2
		75
		106
7
		114
71		2
67
		114
		Black
		Wire
		143
			Red
		71	Wire

8