Weider WESY41080 manual

19. Wrap the Butterfly Cable (89) around a 3 1/2Ó Pulley	19
(82) as shown. Attach the Pulley and a Cable Trap
(80) to the bracket on the Leg Press Upright (4) with a		42
3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). The
		4
Cable Trap must be oriented as shown and be
positioned to hold the Cable in the groove of the		82
Pulley.
		50
		80
		89
20. Locate one of the pre-assembled pairs of Pulley	20
Plates (31) and 3 1/2Ó Pulleys (82).
Route the Butterfly Cable (89) under the indicated
3 1/2Ó Pulley (82). The end of the Pulley Plates (31)		89
with two holes should be downward. Refer to the inset		89
drawing. Make sure the Cable is between the Cable
Trap (80) and the Pulley, and that the Cable Trap is	82	80
positioned to hold the Cable in place.
		50

Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó Nylon	End with
Locknut (42, not shown).	two holes
	should be
31
	down

21.Wrap the Butterfly Cable (89) around a 3 1/2Ó Pulley

(82)as shown. Attach the Pulley and a Cable Trap

(80)to the other side of the bracket on the Leg Press Upright (4) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). The Cable Trap must be oriented as shown and be positioned to hold the Cable in the groove of the Pulley.

22.Note: The Left Arm (6) is shown removed for easi- er part identification. Insert a 5/16Ó x 1Ó Bolt (95) through the bracket on the Left Arm. Fully tighten a 5/16Ó Nylon Jam Nut (91) onto the Bolt.

Slide the free end of the Butterfly Cable (89) onto the 5/16Ó x 1Ó Bolt (95). Thread another 5/16Ó Nylon Jam Nut (91) onto the Bolt, but do not fully tighten it.

Leave enough room between the two Jam Nuts for the Cable to pivot.

21	80
	50
42	89
	82
	4
22
	91
89
95	6

12