Cable must be routed from the direction shown

30.Route the Press Cable (88) over the indicated 3 1/2Ó Pulley (82) attached to the Pulley Plates (31). The

Cable must be routed from the direction shown.

Refer to the inset drawing. Make sure the Cable is between the Cable Trap (80) and the Pulley. Make sure the Cable Trap is positioned to hold the Cable in place as shown in the inset drawing.

Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó Nylon Locknut (42, not shown).

31.Route the Press Cable (88) around a 3 1/2Ó Pulley (82). Attach the Pulley and a Cable Trap (80) to the Leg Press Upright (4) with a 3/8Ó x 3 1/2Ó Bolt (66), a 3/8Ó Washer (38) and a 3/8Ó Nylon Jam Nut (43).

Make sure the Cable Trap (80) is turned to hold the Cable in place.

32.Route the Press Cable (88) around a 3 1/2Ó Pulley (82). Attach the Pulley and a Cable Trap (80) to the Press Frame (12) with a 3/8Ó x 3Ó Bolt (94), a 3/8Ó Washer (38) and a 3/8Ó Nylon Jamnut (43).

Make sure the Cable Trap (80) is turned to hold the Cable in place.

33.Wrap the Press Cable (88) around a ÒVÓ Pulley (81). Attach the ÒVÓ Pulley to the upper bracket on the Leg Press Upright (4) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Jam Nut (43).

30		31
		31
		50
	88	82
		80
		88
31
		4
		43
	88	38
		38
	82
66	80
	80
32
		43
		82
94	38
94		80
		80
	88	12
		12
33
		50
		81
		4
		88
	43

30		31
		31
		50
	88	82
		80
		88
31
		4
		43
	88	38
		38
	82
66	80
	80
32
		43
		82
94	38
94		80
		80
	88	12
		12
33
		50
		81
		4
		88
	43

30		31
		31
		50
	88	82
		80
		88
31
		4
		43
	88	38
		38
	82
66	80
	80
32
		43
		82
94	38
94		80
		80
	88	12
		12
33
		50
		81
		4
		88
	43

30		31
		31
		50
	88	82
		80
		88
31
		4
		43
	88	38
		38
	82
66	80
	80
32
		43
		82
94	38
94		80
		80
	88	12
		12
33
		50
		81
		4
		88
	43