42.Locate the remaining preassembled pair of Pulley Plates (31) and 3 1/2Ó Pulleys (82).
Route the High Cable (85) under the indicated 3 1/2Ó Pulley (82). The end of the Pulley Plates (31) with two holes should be downward. Refer to the inset draw- ing. Make sure the Cable is between the Cable
Trap (80) and the Pulley, and that the Cable Trap is positioned to hold the Cable in place.
Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó Nylon Locknut (42, not shown).
43.Wrap the High Cable (85) around a 3 1/2Ó Pulley (82). Attach the Pulley to the Top Frame (2) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42). The Cable must be routed from the direction shown.
44.Thread a 1/2Ó Plain Nut (35) onto the end of the High Cable (85). Place a 1/2Ó Washer (68) and a 1 1/4Ó x 1/2Ó Weight Spacer (10) on top of the Weight Tube (25).
Thread the end of the Rear Cable (87) into the upper end of the Weight Tube (25) until the Weight Spacer (10) touches the Weight Tube.
Note: It is necessary to lift the Weight Tube (25) with the Top Weight (24) slightly to thread the Rear Cable
(87)in place.
45.Attach the closed loop on the end of the Low Cable
(86)to the bracket on the Lat Upright (1) with the 5/16Ó x 1Ó Bolt (95) and a 5/16Ó Nylon Locknut (40).
Make sure the flat side of the closed loop at the end of the Low Cable (86) is turned towards the bracket.
42 |
|
85 | 85 |
50 | 82 |
| |
31 | 80 |
| |
End with two |
|
holes should |
|
be down |
|
43 |
|
|
|
| 42 |
| 2 | 50 |
|
| |
|
| 82 |
|
| 85 |
44 |
| 85 |
|
| |
|
| 35 |
|
| 68 |
|
| 10 |
|
| 25 |
45 |
|
|
|
| 1 |
| 95 |
|
|
| 86 |
|
| 40 |
18