Weider WESY81081 manual Cable Assembly, Nylon Jamnut. The Leg Lever should pivot freely

13.Press a 1 1/2Ó Square Inner Cap (33) into the Leg Lever (29).

Lubricate a 5/16Ó x 2 1/2Ó Bolt (22). Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and a 5/16Ó Nylon Jamnut (80). Do not overtighten the

Nylon Jamnut. The Leg Lever should pivot freely.

Thread a 5/16Ó Plain Nut (32) one half inch onto the 5/16Ó x 2Ó Eyebolt (44). Thread the Eyebolt into the Leg Lever (29). Tighten the Plain Nut to prevent the Eyebolt from turning.

Note: The use of remaining parts from the ARM ASSEMBLY parts bag will be explained in step 31.

Cable Assembly

14.Locate and open the parts bag labeled ÒCABLE ASSEMBLY AND PULLEYS.Ó For Cable identifica- tion and routing during steps 14Ð28, refer to the Cable Diagram and Cable ID Chart on page 16.

Locate the Short Cable (9). It is approximately 127Ò long. Wrap the end with the ball around a 3 1/2Ó Pulley (35) in the direction shown.

Attach the 3 1/2Ó Pulley to the Top Frame (1) with a 3/8Ó x 3 1/2Ó Bolt (54), a 3/8Ó Flat Washer (55) and a 3/8Ó Nylon Locknut (63).

Make sure the Short Cable (9) is between the Pulley (35) and the welded hook (K) on the Top Frame (1).

15.Wrap the Short Cable (9) around a ÒVÓ-Pulley (6) in the direction shown.

Attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50) to the indicated bracket (J) with a 3/8Ó x 2 1/4Ó Bolt (65) and a 3/8Ó Nylon Locknut (63). Make sure the

Long Cable Trap is positioned as shown, so it will hold the Cable in place.

13	36
		80
	44	22 Lubricate
		29
	32	33
14
63	1
55
	K
	35
		54
	9
15
	J
9
		65
		50
		6
		63

10