31.Press two 3/4Ó Round Inner Caps (34) into each Pad Tube (28).
Insert one Pad Tube into the Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube.
Insert the other Pad Tube into the Leg Lever (29). Slide a Foam Pad (30) onto each end of the Pad Tube.
Miscellaneous Assembly
32.Attach the Curl Pad (24) to the Curl Post (10) with two 1/4Ó x 1/2Ó Screws (17).
Slide the Curl Post (10) onto the Seat Frame (36) so each of the welded brackets are between the Seat Frame and the bracket on the Leg lever (29). Secure the Curl Post with the 5/16Ó x 2Ó Knob (72).
Make sure the Leg Lever (29) can be turned freely after the Curl Post (10) is mounted.
33.Align the Left Shroud (78) with the holes in the Top Frame (1), Base (8) and the two Uprights (18, 42) and attach it with 14 of the #8 x 1/2Ó Tap Screws (7).
Move to the other side of the unit and attach the Right Shroud (79) which is the one with the opening for adjusting the Weights. Align the Right Shroud with the holes in the Top Frame (1), Base (8) and the two Uprights (18, 42) and attach it with 14 of the #8 x 1/2Ó Tap Screws (7).
34.Make sure that all parts have been properly tight- ened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 17 of this manual.
Before using the home gym system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See
15
31 | 30 |
36 | |
| 34 |
28 | 29 |
| |
34 |
|
30 |
|
32 |
|
17 |
|
72 | 24 |
10 |
Welded
Brackets
|
| 36 |
|
| 29 |
33 | 18 |
|
|
| 78 |
|
| 1 |
| 7 |
|
| 7 | 42 |
|
| |
| 7 |
|
| 7 |
|
| 7 |
|
| 79 |
|
| 7 | 8 |