Weider WESY81081 manual Adjustment, Changing the Weight Setting

Page 17

Adjustment

The instructions below describe how each part of the home gym system can be adjusted. Refer to the exercise poster accompanying this manual to see how the home gym system should be set up for each exercise.

IMPORTANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the cor- rect starting position for the exercise to be performed. If there is any slack in the cables or chain as an exercise is performed, the effectiveness of the exercise will be reduced.

Changing the Weight Setting

To change the setting of the weight stack, insert a Weight Pin (39) under the desired Weight (26). Be sure to insert the Weight Pin until the bent end of the Weight Pin is touching the Weights. Then turn the bent end downward. The setting of the weight stack can be changed from 6 pounds to 106 pounds, in increments of 12.5 pounds.

Note: Due to the cables and pulleys, the amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 18 to find the approximate amount of resis- tance at each weight station.

Attaching the Lat Bar, Row Bar or Handle to the High Pulley Station

Attach the Lat Bar (76) to the Short Cable (9) with a Cable Clip (73). For some exercises, the Chain (74) should be attached between the Lat Bar and the Long Cable with two Cable Clips. Adjust the length of the

Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exer- cise to be performed.

The Row Bar (70) or Handle (75) can be attached in the same manner.

Attaching the Lat Bar, Row Bar or Handle to the Low Pulley Station

Attach the Lat Bar (76) to the Long Cable (2) with a Cable Clip (73). For some exercises, the Chain (74) should be attached between the Lat Bar and the Short Cable with two Cable Clips. Adjust the length of the Chain between the Lat Bar and the Short Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Row Bar (70) or Handle (75) can be attached in the same manner.

39

26

9

73

75

74

76

70

2

73

75

74

76

70

17

Image 17
Contents Model No. WESY81081 Serial No QUESTIONS?Limited Warranty Table of ContentsImportant Precautions Before You Begin Four Stages of the Assembly Process AssemblyDo not tighten the Nylon Locknuts yet Frame AssemblyDo not tighten the Locknuts yet Locate and open the parts bag labeled Òarm Arm AssemblyPage Nylon Jamnut. The Leg Lever should pivot freely Cable AssemblyMake sure the Cable Trap 66 is positioned as shown Page Page Locate and open the parts bag labeled Òseat ASSEMBLY.Ó Seat AssemblyMiscellaneous Assembly Short Cable Cable DiagramCable ID Chart Long Cable Changing the Weight Setting AdjustmentWeight Resistance Chart Tightening the Cables Trouble-shooting and MaintenanceExploded DrawingÑModel No. WESY81081 Qty Description Part ListÑModel No. WESY81081Page Part Identification ChartÑWESY81081 Page Ordering Replacement Parts